Summary of Contents for LIT VISIUM 1
- Page 1 Installation Guide Scan QR Code for product information and other helpful resources. LitThinking.com/installation...
- Page 2 Table of Contents Safety Information Package Contents Preinstallation & General Guidelines Mounting Guidelines Technical Specifi cations Recessed Mount Installation Guide Surface Mount Installation Guide Pendant Mount Installation Guide Service and Maintenance Troubleshooting & Warranty | Visium 1 Installation Guide LitThinking.com/installation | 3...
-
Page 3: Safety Information
GERMICIDAL LAMPS OR UV SOURCES AND MUST BE INSTALLED IN COMPLIANCE WITH COMPETENT TECHNICAL DIRECTIONS TO PREVENT THE USER’S EYE AND BARE SKIN FROM OVEREXPOSURE TO HARMFUL UV OR OPTICAL RADIATION. Continued... | Visium 1 Installation Guide LitThinking.com/installation | 5... -
Page 4: Package Contents
When replacing equipment, replace only with the lamps for which the equipment is marked and intended. USE ONLY Lit Part Number: LIT UVC222 Module B1.5 DO for Visium 1 with Di used Optics and LIT UVC222 Module B1.0 CO for Visium 1 with Clear Optics. -
Page 5: Preinstallation Notes
It is not intended to be a replacement for number of air changes per hour (ACH), proper air ventilation, or proper air fl ow. • Visium 1 are intended to be used in spaces with greater than 2 air changes per hour (>2 ACH). -
Page 6: Mounting Guidelines
Visium 1 - Di used Optics 7ft 4in Plane For compliance with UL safety standards, illuminating surface of the Visium 1 with Di used Optics is required to be 7ft 4in, or higher, above the fl oor. Visium 1 - Clear Optics... - Page 7 Prepare the Area Run Wires Through J-Box into the 6in opening in ceiling, and allow the to device setup by using the Lit Thinking Connect App that can be downloaded from mounting clips to engage with the ceiling, Trim device wires in preparation for wiring.
- Page 8 SURFACE INSTALLATION STEPS: Proceed to Device Setup Mount the Device Hardware installation is complete. Proceed Mount Visium 1™ by inserting the retention Install the J-Box Run Wires Through Bracket to device setup by using the Lit Thinking studs on the mounting bracket into hole of Connect App that can be downloaded from the device.
- Page 9 NOTE: If installing onto T-grid ceilings, a 3rd party T-Bar Hanger can be purchased and installed prior to device installation. Set Screw Attached ground wire from Crossbar Plate Continued... | Visium 1 Installation Guide LitThinking.com/installation | 17...
- Page 10 Push all wire connections into to device setup by using the Lit Thinking cover. Attach green ground wire to stem with provided ground J-Box and install Monopoint Crossbar Plate Connect App that can be downloaded from screw.
-
Page 11: Service And Maintenance
Service and Maintenance When to Replace Lamp: The integral Far-UVC lamp within Visium 1 has an operating life of up to 10,000 Cleaning: hours. When the LED status light on the face of the device turns solid yellow ( it indicates the Far-UVC lamp is near the end of its life and will require replacement Routine cleaning is highly recommended to maintain optimal performance. -
Page 12: Troubleshooting
White ( ) and is now ready for commissioning. Insert a paper clip to depress and hold the Warranty 1 year limited warranty on Visium 1 device / 1 year limited reset button for 3-5 seconds (but no more than warranty on Far-UVC Lamp and lamp electronics. - Page 13 Visium 1 Installation Guide...
Need help?
Do you have a question about the VISIUM 1 and is the answer not in the manual?
Questions and answers