Hoyles EchoStream EE1223D Manual

EE1223D EchoStream® Double-Button Water-Resistant Pendant Transmitter
Overview
The Inovonics double-button water-resistant pendant
transmitter is small, light and versatile.
Transmitter External Components
Figure 1
A Transmit LED
B Activation buttons
C Reset button
Transmitter Internal Components
Figure 2
A EchoStream select compatibility selection pins
B Battery
C Reset button plunger assembly
What's In The Carton
•
One EchoStream double-button water-resistant
pendant transmitter.
•
One breakaway neck cord.
•
One beltclip attachment.
•
Three housing screws.
•
One selection jumper
•
One CR2450 coin cell battery.
Installation Notes
•
These products are designed to be maintained
by professional security technicians.
•
Products are intended for indoor use.
•
All products should be manually tested weekly.
Battery Installation
1. Remove the rear housing cover to expose the
side of the board that holds the battery.
Caution – Carefully separate the rear housing cover,
ensuring the reset button plunger assembly does not fall
out of the housing (figure 2)
2. Slide the battery under the battery holder.
Ensuring that it is fully inserted and that the
positive terminal (+) faces up (figure 2).
3. Press the reset button.
Select the EchoStream Select Compatibility
To meet ETSI requirements, Inovonics has developed a
new line of EE 868MHz-only products. These new
868MHz-only products are compatible with older
systems that include EchoStream select products. If you
are using any ES products in your current system, you
will need to enable EchoStream select compatibility on
this new 868MHz-only product; if you are not using any
EchoStream select products, skip to "Register the
Transmitter".
To enable/disable EchoStream select compatibility:
4. Turn the board over to access the side with the
frequency band selection pins (figure 2).
5. Place a selection jumper on the middle two
EchoStream select compatibility selection pins.
6. Press the reset button.
Register the Transmitter
The transmitter must be registered and supervised.
When supervised, the transmitter will send check-in
message to the receiver or gateway as follows every 12
minutes.
Each transmitter has a unique factory-programmed
identification number. Refer to the receiver or gateway's
installation instructions for details on registering and
setting up supervision.
Hoyles Electronic Developments Ltd
Sandwash Close, Rainford, St Helens, WA11 8LY, UK
www.hoyles.com
sales@hoyles.com
+ 44 (0) 1744 886600