3Com SSII ADVANCED RPS Y CABLE TYPE 3 Installation Manual
3Com SSII ADVANCED RPS Y CABLE TYPE 3 Installation Manual

3Com SSII ADVANCED RPS Y CABLE TYPE 3 Installation Manual

Superstack 3 advanced rps type 3 'y' cable

Advertisement

S
UPER
RPS T
(3C16077) I
For installation by suitably qualified
service personnel only.
CAUTION: An energy hazard may exist on the Type 3 Power Module
DC connector when the Module is in the Advanced RPS chassis.
This guide provides all the information you need to connect a Type 3
Power Module (3C16075) to a SuperStack 3 unit using a
SuperStack
3 Advanced RPS Type 3 'Y' cable (3C16077).
®
This guide is intended for use by suitably qualified service personnel
who are responsible for installing and setting up network equipment.
®
S
TACK
3 'Y' C
YPE
NSTALLATION
3 A
DVANCED
ABLE
G
UIDE

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SSII ADVANCED RPS Y CABLE TYPE 3 and is the answer not in the manual?

Questions and answers

Summary of Contents for 3Com SSII ADVANCED RPS Y CABLE TYPE 3

  • Page 1 ® UPER TACK DVANCED RPS T 3 ‘Y’ C ABLE (3C16077) I NSTALLATION UIDE For installation by suitably qualified service personnel only. CAUTION: An energy hazard may exist on the Type 3 Power Module DC connector when the Module is in the Advanced RPS chassis. This guide provides all the information you need to connect a Type 3 Power Module (3C16075) to a SuperStack 3 unit using a SuperStack...
  • Page 2 UIDE Introduction The SuperStack 3 Advanced RPS (3C16071, 3C16071A, or 3C16071B) provides redundant power to the products in the 3Com SuperStack 3 family. The optional Type 3 Power Module Advanced RPS ‘Y’ cable (3C16077) provides DC power from two Type 3 Power Modules to a SuperStack 3 unit when full redundancy (resilience) is required.
  • Page 3 Connecting the ‘Y’ Cable Verbinden sie das Kabel nur mit dem vorgesehenen RPS Ausgang. Bei nicht Beachtung wird das RPS und der SuperStack 3 beschädigt. Connecting the ‘Y’ Cable The SuperStack 3 Advanced RPS and its modules can be “hot-connected” to SuperStack 3 units, that is, you do not need to remove power from the chassis or other units to connect the cables.
  • Page 4 Unless otherwise indicated, 3Com registered trademarks are registered in the United States and may or may not be registered in other countries. 3Com and SuperStack are registered trademarks of 3Com Corporation. The 3Com logo is a trademark of 3Com Corporation.

This manual is also suitable for:

3c16077

Table of Contents