NAPCO VERI-PHONE Quick Start Manual

R
333 Bayview Avenue
Amityville, New York 11701
For Sales and Repairs, (800) 645-9445
For Technical Service, (800) 645-9440
© NAPCO 2004
These instructions are abbreviated procedures for programming and wiring the Veri-Phone two-way voice module. For detailed in-
structions, refer to WI844 and WI1197.
PROGRAMMING THE VERI-PHONE
NOTE: When entering Programming Mode, entry key sequence must be completed within 10 seconds--otherwise place
phone back on hook, pick up and start again.
To Program the Veri-Phone™, enter the following keystrokes on the TouchTone phone. Feedback
beeps will confirm proper programming - (7 beeps indicate an invalid entry, re-enter field).
•
To Enter the Default Program:
#*
(Beep) PAUSE (Beep) Beep) (Loads default Program shown in parenthesis)
•
To Change User Code:
#2
(Beep)
(1)
•
To Change Dealer Code:
#3
(Beep)
(4)
•
To Change Hardware Configuration Options:
#4
(Beep)
(0)
Select Method of Enable
Veri-Phone™ Fast
Activation. Trigger?
Trigger or Sense
0 = No
Method?
1 = YES
0 = Trigger Method
1 = Sense Method If required,
select a 1
If using a Control second
Panel that has a trigger in-
Listen-in, NTO or stead of a
PGM Lug, select 5 second
the Trigger trigger.
Method.
QUICK START GUIDE
Note: The User Code is changed to the default fac-
tory settings only through Power-Up Programming
*
(2) (3) (4) (5) (6)
*
(5) (6) (7) (8) (9)
*
(0) (0) (0) (0) (0)
Activate with
Time-Out Control
Listen or VOX
Mode?
0 = Standard Default = 4 minutes.
1 = 1 minute
0 = Listen
2 = 2 minutes
Mode
3 = 3 minutes
1 = VOX Mode
4 = Enable CSAVM.
Note: Entries 0 through 3 all become 4 min-
Select the
utes once the Operator is on line. If you are
state in which
uncertain if your telephone network supports
the Veri-
call party disconnect, then program the time
Phone™ will
which most closely matches the hold dura-
initiate the Au-
tion of the Central Station receiver.
dio Session.
VERI-PHONE
(Beep) (Beep) (If Less Than 6 digits, press
(For Power-Up Programming Only)
(Beep) (Beep) (If Less Than 6 digits, press
Hardware Configuration Information
(Beep) (Beep)
™
WI844B-GEN 12/04
Note: Dealer Pro-
gramming timeout
(indicated by 7 error
beeps) occurs if the
Veri-Phone™ does
not receive Touch-
Tone commands for
*
when done).
more than 1 minute. If
necessary, re-enter
Dealer Programming.
*
when done).
Disable
Exclusive
Microphone
Selection?
0 = NO
1 = YES
Disables indi-
vidual micro-
phone selec-
tion.
Activate The
Audio
Session with
Microphones
in
0 = All Mics ON
1 = Mic 1 ON
Select the state
of the micro-
phones at the
start of the au-
dio session.