Subscribe to Our Youtube Channel
Related Manuals for Petsafe DELUXE PIG22-11868
Summary of Contents for Petsafe DELUXE PIG22-11868
- Page 1 In-Ground F E N C E PIG22-11868 Operating and Training Guide Operating and Training Guide LITTLE DOG Please read this entire guide before installation.
-
Page 2: Table Of Contents
To get the most protection out of your warranty, please register your product within 90 days at www.petsafe.net. By registering, you will enjoy the product’s full warranty and should you ever need to call the Customer Care Center, we will be able to help you faster. Additionally, you will not have to save your product receipt as registering serves as proof of purchase. -
Page 3: Components
Bracket Boundary Wire - 500 ft. Power Boundary Flags - 50 Adapter Fence Installation Transmitter and Training Battery ® (PetSafe RFA-188) Wire Nuts Receiver Collar Test Light Operating and Gel-filled Tool Training Guide Capsules Other Items You May Need • Additional wire and fl ags (Part #PRFA-500) •... -
Page 4: How The System Works
How the System Works The PetSafe In-Ground Fence has been proven safe, comfortable, and effective for all pets over 6 months of age and those ® weighing up to 25 kg (55 lbs) with neck sizes 15-66 cm (6"-26"). The system works by producing a radio signal from the Fence Transmitter through up to 1200 m (4000 feet) of Boundary Wire. -
Page 5: Operating Guide
30 Twists/m provided in the back of this guide. wists/ft. • Fence planning software is available online at www.petsafe.net/fence. After you have planned and saved your layout online, contact our Customer Care Center to review and refi ne your layout. -
Page 6: Sample Layouts
Twist the wire from A back to separated 1-1.5 m (3-5 ft). separated 1-1.5 m (3-5 ft). Twist the Fence Transmitter. Twist the wire from A back to the wire from A back to the the Fence Transmitter. Fence Transmitter. www.petsafe.net... -
Page 7: Position The Boundary Wire
Snap the lid of the capsule shut (3F). For proper system performance, the splice connection must be waterproof. If your splice pulls loose, the entire system will fail. Make sure your splice is secure. Additional gel-fi lled splice capsules and wire nuts are available through the Customer Care Center. www.petsafe.net... -
Page 8: Connect The Wires To The Fence Transmitter
The Fence Transmitter is also equipped with a 250 volt, ½ amp fuse to protect the unit’s electronic circuitry from electrical power surges. To locate the fuse, slide off the lid on the back of the Fence Transmitter. A spare fuse is also provided. www.petsafe.net... -
Page 9: Prepare The Receiver Collar
Prepare the Receiver Collar Step To Insert and Remove the Battery Note: Do not install the battery while the Receiver Collar is on your pet. This Receiver Collar utilizes a replaceable PetSafe ® battery (RFA-188). This unique battery is designed to make battery replacement easier and increase water protection. -
Page 10: Set The Boundary Width And Test The Receiver Collar
If you are satisfi ed that your system is functioning properly, you are ready to start burying the Boundary Wire. If the Receiver Collar did not beep or the Test Light did not fl ash, see the “Troubleshooting” section (Page 17). Note: The Boundary Width is broken down into 20% Warning Zone and 80% Static Correction Zone. www.petsafe.net... -
Page 11: Install The Boundary Wire
3. Use a blunt tool such as a wooden paint stick to push the Boundary Wire into the trench. Be careful not to damage the Boundary Wire insulation. To Attach the Boundary Wire to an Existing Fence The Boundary Wire of the PetSafe ® In-Ground Fence can be attached to a chain link fence, split rail fence, or a wooden privacy fence. -
Page 12: Place The Boundary Flags
Important: Do not attach a leash to the collar. This can result in pulling the Contact Points too tightly against your pet’s neck. Attach a leash to a separate, non-metallic collar or harness, making sure the extra collar does not put pressure on the Contact Points. www.petsafe.net... -
Page 13: Training Guide
Contact Points, may occur if the steps above are not followed. Training Guide Be Patient With Your Pet Important: Proper training of your pet is essential to the success of the PetSafe ® In-Ground Fence. Read this section completely before beginning to train your pet. Remember that the PetSafe ®... -
Page 14: Days 2 Thru 4 - Continue Boundary Flag Awareness
2. Drop the leash, leaving your pet in the Pet Area. 3. Walk outside the boundary and wiggle the Boundary Flags facing your pet. 4. Continue around the entire boundary doing this, tossing treats to your pet in the Pet Area and praising him. www.petsafe.net... -
Page 15: Days 5 Thru 8 - Distraction Phase
Your pet is ready to run! Check in on your pet at regular intervals. Note: After you are satisfied your pet’s training is complete, remove every other Boundary Flag every 4 days until all flags are removed. Save Boundary Flags for future use. www.petsafe.net... -
Page 16: Days 31+ Tone Only Training
__________________________________________________ Accessories To purchase additional accessories for your PetSafe ® In-Ground Fence, visit our website at www.petsafe.net to locate a retailer near you and for a listing of Customer Care Center telephone numbers in your area. Component Part Number Battery... -
Page 17: Troubleshooting
Boundary Wire. See the “Locating a Break in the Wire” section in this guide (page 18). The fuse blows when it is replaced. • The Fence Transmitter and/or Power Adapter needs to be replaced. Contact the Customer Care Center. www.petsafe.net... -
Page 18: Additional Information
• This system is not for vicious or aggressive pets. If your pet may pose a threat to others, DO NOT USE THIS SYSTEM. If you are unsure if your pet is aggressive, please consult your veterinarian or a certifi ed trainer. • The PetSafe In-Ground Fence is for residential use only. -
Page 19: Battery Disposal
Product Warranty Please register your product online at www.petsafe.net. All parts are covered under warranty for the life of this product. Labor is covered for the first year of ownership. Thereafter, there is a minimum service charge for the repair or replacement of the product. -
Page 20: Compliance
Therefore, if you have reason to believe that your pet may pose a danger to others or harm himself if he is not kept from crossing the boundaries, you should NOT rely solely upon the PetSafe ®... - Page 21 www.petsafe.net...
- Page 22 www.petsafe.net...
- Page 23 www.petsafe.net...
-
Page 24: Layout Grid
Layout Grid Radio Systems ® Corporation 10427 Electric Avenue Knoxville, TN 37932 865-777-5404 www.petsafe.net 400-1057-22 Covered by US Patents 6,921,089 and D531,117. ©2008 Radio Systems ® Corporation...
Need help?
Do you have a question about the DELUXE PIG22-11868 and is the answer not in the manual?
Questions and answers