Related Manuals for Smart Cabling & Transmission IP01F
Summary of Contents for Smart Cabling & Transmission IP01F
- Page 1 Ethernet Extender User Manual Model：IP01F Ethernet to Fiber Media Converter/Extender V1.0...
-
Page 2: Transmission Distance
IP01F Introduction IP01F is a networking device capable of transmitting data communication protocol including Ethernet, Fast Ethernet, and Gigabit Ethernet over fiber optics. The transmission distance can reach up to 20km over a single-mode fiber module and single-core fiber cable. The plug and play media converter is an ideal solution for CCTV network, AVoIP system, and IT infrastructure. -
Page 3: Panel View
User Manual IP01F Panel View Interface Description Power Input To input a DC5V power RJ45 To connect a network cable SC Fiber Connector To connect a single fiber cable LED Indicators To indicate the status of power and connection LED Indication... - Page 4 User Manual IP01F • Using CAT.5e UTP/ STP/ FTP, and CAT.6 UTP (Solid Conductor) cables are recommended, the greater the diameter of the cable, the fewer the signal loss. • To enable Jumbo frame, both Tx and Rx devices should enable the function at the same time.
-
Page 5: Specification
User Manual IP01F Specification Item No IP01F Support IEEE802.3 10BASE-T IEEE802.3u 100BASE-T Compliance IEEE802.3ab 1000BASE-T IEEE802.3z 1000BASE-SX/1000BASE-LX IEEE802.3az Ethernet: 100M over a network cable Max. Transmission Distance Fiber: 20 ㎞ over single mode single fiber Data Bandwidth 10/100/1000Mbps Jumbo Frame... - Page 6 User Manual IP01F Installation Guide Accessory Machine Screw Self-drilling Screw Screw Plug Angle Bracket DIN-rail Mounting Plat 1U Rack Installed on a Platform Step 1 Use machine screws to fix angle brackets on both sides of your product...
- Page 7 User Manual IP01F Step 2 Use self-drilling screws to fix the product on a platform Step 3 Move the product to get fixed and then lock the screws...
- Page 8 User Manual IP01F Installed on Wall Step 1 Same way as “Installed on a Platform”, but need to put screw plugs into the pilot hole before inserting the screws (leave 2mm space from the platform) Installed on a DIN-rail Step 1 Use machine screws to fix a DIN-rail mounting plat on the side of your product...
- Page 9 User Manual IP01F Step 2 Install your product on a DIN-rail as following instruction Installed on a Rack Step 1 Lock machine screws in the rack Step 2 Put your products on the rack...
- Page 10 User Manual IP01F Step 3 Push the products to the other side of the rack Step 4 Install the rack in a cabinet...
Need help?
Do you have a question about the IP01F and is the answer not in the manual?
Questions and answers