Advertisement
Quick Links
LAE 4 Fridge Controller Guide
This display shows the current temperature. This reading is showing 6.4°.
This button is to check the low temperature. This low temperature is reading 1.9°.
ROLLEX MEDICAL NZ LTD
38E Highbrook Drive, East Tamaki, Auckland 2013
PO Box 204159, Highbrook, Auckland 2016
Phone: 09 274 0707
Fax: 09 274 0709
Web: www.rollexmedical.co.nz
Email: nzsales@rollexmedical.co.nz
Advertisement
Summary of Contents for Rollex Medical LAE 4
- Page 1 Phone: 09 274 0707 Fax: 09 274 0709 Web: www.rollexmedical.co.nz Email: nzsales@rollexmedical.co.nz LAE 4 Fridge Controller Guide This display shows the current temperature. This reading is showing 6.4°. This button is to check the low temperature. This low temperature is reading 1.9°.
- Page 2 To reset the low temperature in memory, hold the temperature button and press “set” at the same time. This button is to check the high temperature. The temperature is reading 7.7°. To reset the high temperature in memory, hold the temperature button and press “set” at the same time.
- Page 3 “dF” stands for defrost. Standard programming ensures the fridge defrosts for 6 minutes every 8 hours to prevent ice buildup. This is not an error message. By holding “◄◄ - ◄ “ and “► - ►►” buttons together this forces the fridge into defrost mode for the programmed time and will then continue its normal operation.
- Page 4 3 seconds. If the “HI” alarm is going off it may be from the door being left open or a power cut if one has occurred. If the alarm condition persists please contact us. Rollex Medical Head Office Phone: 0800 249 3722 Email (Service): nzservice@rollexmedical.co.nz If you would like any further clarification on any of these matters please get in touch with us.
- Page 5 The Rollex Lae 4 Controller This can display temperatures in degrees Fahrenheit or Celsius. Typically it will be displayed in decimals although whole degrees can be used. Normal operation is between 2.7° – 6.0° although climate and room temperatures will have an effect on this.
- Page 6 Reading and resetting the memory The memory on the controller is MIN MAX, it stores the lowest and highest temperatures since the last reset. Pressing the << button will display the low temperature and >> will display the high temperature. To clear the controller low memory you MUST PRESS AND HOLD the <<...
Need help?
Do you have a question about the LAE 4 and is the answer not in the manual?
Questions and answers