CME-USB01
Please thoroughly read this instruction sheet before installing option cards and putting them into
use.
The content of this instruction sheet may be revised without prior notice. Please consult our
distributors or download the most updated version at http://www.delta.com.tw/industrialautomation/.
Layout
USB Card (CME-USB01)
Installation
Make sure that the AC Motor Drive is powered
off before operation. DO NOT insert or remove
the card when the AC Motor Drive is powered
on.
Please mount the extension card as shown and
fix it with the screw packed with the card.
USB Cable
USB Type B to CME-USB01
NOTE
Refer to Chapter 5: Parameters 9 (Group 9) in
the user manual for further details.
USB Interface for VFD-E Series Instruction Sheet
Screw torque:
Maximum 2kgf-cm
USB Type A to PC
Specification
Environmental
o
Operating
-10
C to 50
Temperature
and not frozen)
Storage
o
-20
C to + 60
Temperature
Ambient
Less than 90%RH
Humidity
(non-condensing)
Installation
Below 1000m
Altitude
Less than 20Hz:
Maximum 9.81 m/s
Vibration
20 ~ 50Hz:
Maximum 5.88 m/s
NOTE
Always use this product in a clean indoor
location free from dust, corrosive gas and liquid.
Inputs/Outputs
Supports 4800, 9600, 19200,
Baud Rate
38400, 57600 bps.
USB
USB v1.1
Specification
Notes
Please use shielded wires to avoid interferences
and connect the shield to ground.
To avoid interference, route the extension card
wires separately and as far away (at least 15cm)
as possible from other control wires, motor wires
and power wires, etc. Where these wires must
cross each other, please make sure they are at
o
a 90
angle.
Always use and operate this product within the
limit of its specifications.
2007-07-09
5011659301-SBT1
o
C (non-condensing
o
C
2
(1G);
2
(0.6G)