Summary of Contents for RIKA RK120-07
- Page 2 The ownership of this manual belongs to Hunan Rika Electronic Technology Co., Ltd (Named as Rikasensor in below). It cannot be copied or reproduced for commercial use without permission.
- Page 3 Ultrasonic Automatic Weather Instrument...
- Page 4 When the RK120-07Ultrasonic Automatic Weather Instrument is transported to the installation site, the instrument must be placed in the inner package.Do not throw away any packaging material. The equipment can be used for frequent transportation. 7. Outside Drawing The outside drawing of RK120-07 Ultrasonic Automatic Weather Instrument...
- Page 5 Ultrasonic Automatic Weather Instrument...
-
Page 6: Installation Caution
Note: the final label on the communication cable shall be subject to the label. 9 Installation Caution RK120-07 Ultrasonic Automatic Weather Instrument can meet or even exceed the specifications listed in it, and can be used in different environments around the world without maintenance and calibration. - Page 7 RK120-07 can be fixed on the installation pipe by three stainless-steel screws (the maximum installation torque of the screws is 4Nm). You must ensure that the RK120-07 is installed in an open area to avoid obstruction or turbulence caused by surrounding buildings. Do not install it close to high-power radar or radio transmitters.
- Page 8 The instrument has no moving parts, and does not require routine maintenance. If you open the instrument or damage the safety seal on it, you will no longer be entitled to our quality assurance and calibration. If there is any problem with the instrument, you can send it to the authorized agent of Rika. 13. Instrument return If the instrument needs to be returned, please pack it carefully according to the original packaging, and send it to the authorized agent of Rika., attaching detailed failure instructions of the instrument.
- Page 9 Ultrasonic Automatic Weather Instrument 15 .Instrument configuration(you can choose ASCII or Hex) Through the connecting with the instrument, some parameters of the instrument can be configured, such as changing the communication address and changing the Baud rate Command one: Enter the Settings mode Sent ASCII >*\r\n...
- Page 10 4. "\r\n" is the carriage return line feed, corresponding to HEX (0x0D,0x0A) Hunan Rika Electronic Tech Co.,Ltd Add: T:+86-731-85132979 E:info@rikasensor.com W:www.rikasensor.com Specifications subject to change without notice. Version 1.0 Copyright © 2015 Hunan Rika Electronic Tech Co.,Ltd...
Need help?
Do you have a question about the RK120-07 and is the answer not in the manual?
Questions and answers