Epever DCCP-DPI Series Instruction Manual

BEIJING EPSOLAR TECHNOLOGY CO., LTD.
※Thank you for selecting the DCCP DPI series LED driver. Please read
this manual carefully before using the product.
※Please keep this product manual for future reference.
DCCP DPI Series DC LED Driver
1. Overview
DCCP-DPI Series DC LED driver adopts the step-up voltage control, constant
current driver design. The rated current range and working time is adjustable via
infrared communication. The IP68 protection allows this series to fit both indoor
and outdoor LED lightings, especially for solar LED lighting application.
 Maximum output efficiency of 95.7%
 Flexible dimming function (0-100%)
 Programmable via IR communication
 Wide working environment temperature（-40℃～75℃）
 Long lifespan design
 Fully encapsulated PCB, IP68 protection (1.5 meters, 72h)
 Aluminum housing for better cooling
2. Product Features
①
② ③
④
Figure 1 Characteristic
1
⑤ ⑥ ⑦
Tel: +86-10-82894112 / 82894962 Website:www.epsolarpv.com/www.epever.com
Mounting Hole Φ4
①
② Input Positive Wires
③ Input Negative Wires
④
LED load Positive Wires
3. Wiring and Setting
LED Lights
 Wiring Order
Step1: LED lights
Step2: Battery or DC supply power (Input Voltage range is 9～33V)
Note: ①Suggest input terminal connect the fuse and DO NOT insert the fuse or
during the installation.
②Please pay attention to the "+" and "-".
③When disconnecting the system, the order will be reserved.
Step3: After power on the LED driver, check the LED will be ON. If it's not ON,
please refer to chapter 5.
 Setting Operation
Set parameters through RC-03(Infrared Communication
：
Remoter)
 Time1, Time2, Time3,

LED working Current
Reference for the table of chapter 4 or the RC-03 user
manual.
RC-03
⑤
LED load Negative Wires
⑥ Infrared LED
⑦ Infrared Receiver Module
LED Driver
Figure 2 Wiring
2