Summary of Contents for Boss NanoEdge
- Page 1 NanoEdge Flexible Solar Panels System Installation Manual AUSTRALIAN 10 YEAR SAVE ON SIMPLY WARRANTY MADE FREIGHT ROLL OUT Australian Made Solar Pool Heating Proudly Manufactured by:...
-
Page 2: Table Of Contents
Simultaneous/Integrated/Retro Fit Configuration Manual System Configuration Ancillary Components Installation VacRel Vacuum Relief Valve Drain Down Tube TufGauge Pressure Gauge Troubleshooting Guide NanoEdge Flexible Solar Panels Installation Manual | Boss Pool Heating NanoEdge Flexible Solar Panels Installation Manual | Boss Pool Heating... -
Page 3: Introduction
When installing a solar system, always exercise extreme caution when working with heights or around water; do not use short cuts, as there is no substitute for safety. The installer of any Boss Pool Heating System (or component) must accept responsibility 1x VacRel... -
Page 4: Planning And Designing The System
Most solar systems include a separate pump or automatic solar controller to maximise heating efficiency and can be fitted with the system. NanoEdge Flexible Solar Panels Installation Manual | Boss Pool Heating NanoEdge Flexible Solar Panels Installation Manual | Boss Pool Heating... -
Page 5: Installing The System
Panels until all your panels are laid out and ready for installation. Ensure your coils are straight and lined up on the roof. NEED SUPPORT ON INSTALLING THE SYSTEM? CALL BOSS POOL SCAN HEATING FOR SUPPORT ON 1300 489 786 OR FIND OUT MORE BY... - Page 6 Roof Mount with the bottom clamp. technique used as per step 6. the roof. Repeat this until all Roof Mounts are secured. NanoEdge Flexible Solar Panels Installation Manual | Boss Pool Heating NanoEdge Flexible Solar Panels Installation Manual | Boss Pool Heating...
- Page 7 Lift the tile and slide the EzyTie Roof Tile Tie Release the tile to securely lock it into place. underneath until it hooks onto the tile below. NEED SUPPORT ON INSTALLING THE SYSTEM? CALL BOSS POOL NEED SUPPORT ON INSTALLING THE SYSTEM? CALL BOSS POOL SCAN...
- Page 8 If installing the bottom of the system roof mounts, DO NOT fasten them to the tile NEED SUPPORT ON INSTALLING THE SYSTEM? CALL BOSS POOL SCAN HEATING FOR SUPPORT ON 1300 489 786 OR FIND OUT MORE BY...
-
Page 9: Plumbing Configurations
Plumbing Configurations Australian Made Pool Solar Heating NanoEdge Flexible Solar Panels Installation Manual Independent / Separate Suction System Configuration Simultaneous/Integrated/Retro Fit Configuration The pool water is pumped directly from the pool to the solar collector and then back. This configuration This system involves diverting the flow of water after the filtration system. -
Page 10: Manual System Configuration
Plumbing Configurations Ancillary Components Installation VacRel Vacuum Relief Valve Manual System Configuration (No pump or digital controller) Involves plumbing into the filtration line and manually opening and closing a three-way valve to divert water The ideal position for the VacRel is in a 40mm PVC Tee-Fitting on to the system. -
Page 11: Troubleshooting Guide
Please take images and/or videos clearly showing the issue and send them through your Defect local store along with proof of purchase. NanoEdge Flexible Solar Panels Installation Manual | Boss Pool Heating NanoEdge Flexible Solar Panels Installation Manual | Boss Pool Heating... - Page 12 NanoEdge Flexible Solar Panels AUSTRALIAN 10 YEAR SAVE ON SIMPLY WARRANTY MADE FREIGHT ROLL OUT Australian Made Solar Pool Heating Proudly Manufactured by:...
Need help?
Do you have a question about the NanoEdge and is the answer not in the manual?
Questions and answers