TRAC 1T1R User Manual

802.11a/b/g/n WiFi & BLE 4.2 Module 1T1R
It is a highly integrated single-chip 802.11a/b/g/n 1T1R WLAN, and an integrated Bluetooth Low
Energy 4.2 combo chip with USB 2.0 multi-function. It combines a WLAN MAC, a 1T1R capable
WLAN baseband, BT Protocol Stack, BT Baseband, modem, and WLAN/BT RF in a combo chip. It
provides a complete solution for a high-performance integrated wireless LAN and Bluetooth controller.
General
QFN40 5 x 5 mm
802.11a/b/g/n 1T1R WLAN and Bluetooth Low Energy (BLE) 4.2 combo chip
Host Interface
Complies with USB2.0 for WLAN and BT controller
USB Multi-Function for both BT (USB function 0) and WLAN (USB function 1)
USB LPM and USB Selective Suspend supported
Important Notice to OEM integrators
1. This module is limited to OEM installation ONLY.
2. This module is limited to installation in mobile or fixed applications, according to Part 2.1091(b).
3. The separate approval is required for all other operating configurations, including portable
configurations with respect to Part 2.1093 and different antenna configurations
4. For FCC Part 15.31 (h) and (k): The host manufacturer is responsible for additional testing to verify
compliance as a composite system. When testing the host device for compliance with Part 15 Subpart B,
the host manufacturer is required to show compliance with Part 15 Subpart B while the transmitter
module(s) are installed and operating. The modules should be transmitting and the evaluation should
confirm that the module's intentional emissions are compliant (i.e. fundamental and out of band
emissions). The host manufacturer must verify that there are no additional unintentional emissions
other than what is permitted in Part 15 Subpart B or emissions are complaint with the transmitter(s)
rule(s). The Grantee will provide guidance to the host manufacturer for Part 15 B requirements if
needed.
IMPORTANT NOTE:
In the event that these conditions can not be met (for example certain laptop configurations or
co-location with another transmitter), then the FCC authorization is no longer considered valid and the
FCC ID can not be used on the final product. In these circumstances, the OEM integrator will be
responsible for re-evaluating the end product (including the transmitter) and obtaining a separate FCC
authorization.
End Product Labeling
The final end product must be labeled in a visible area with the following:
"Contains Transmitter Module FCC ID:2AG7C-R833 or Contains FCC ID:2AG7C-R833 ".
Manual Information to the End User
The OEM integrator has to be aware not to provide information to the end user regarding how to install
or remove this RF module in the user's manual of the end product which integrates this module.
An intentional radiator shall be designed to ensure that no antenna other than that furnished by the
responsible party shall be used with the device. The use of a permanently attached antenna or of an
Module User Manual