Adaptive FP-AM7315-3X1-B Installation Manual

Installation Guide
Installation Procedure:
Step 1: Flip speakers so that the bottom is facing up. Unscrew existing
speaker screws and discard.
Step 2: Determine the splay angle of the speaker and the holes to use
on the front joiner plate (Figure 2).
Figure 2
Need
Drawings
From
Terrence
Adaptive Technologies Group
1635 E. Burnett Street | Signal Hill, CA 90755 USA
Ph: 562.424.1100 | Fax: 562.424.3520
www.adapttechgroup.com
3 WIDE X 1 DEEP PLANAR ARRAY CONFIGURATION
The FP-AM7315-3X1 planar array kit give designers, contractors and audio consultants
the ability to create a three wide AM6315, or AM4315, or AM6340 speakers in a tight
pack planar array confi gurations. The FasPac TM provides a method of fl ying a tight
pack array while offering the capability of allowing cabinets to be adjusted relative to
each other to fi nd the optimum sound directivity. A series of holes are provided to easily
adjust the splay angle from 0° to 30° at an increment of 2.5 degree.
Installing speakers must be performed by experienced professionals. If in doubt
about the integrity of the structure you are mounting or suspending to or not sure about
the proper hardware or method to use, consult a certifi ed rigging company.
Contents:
Be sure that all of the following items are included in this kit before proceeding:
4 pcs. Front Rear Joiner Plates
2 pcs Rear Joiner Plates
14 pcs M10x1.5-45MM
15 pcs M10 Flat Washers
ALWAYS INSTALL SAFETY CABLES
WARNING: Mounting and/or suspension of audio and video equipment requires
experienced professionals. Improperly installed loudspeakers can result in property
damage, personal injury and/or liability to the installing contractor.
FP-AM7315-3X1-B
Need
Drawings
From
Terrence
Step 3: Install the rear joiner plate on the rear rigging
inserts to secure the side speakers to the center
using the slots of the plates. Use the provided M10
screws and washers (Figure 1). Install two front
joiner plates on the two front rigging inserts of the
speakers using the corresponding holes for the
appropriate splay angles using the, screws, and
washers (Figure 1). Make sure the markings on the
plates are facing up. Do not tighten screws; leave it
snug until all plates are in position.
Step 4: Slowly fl ip the speaker assembly so that
the tops of the speakers are facing up. Unscrew the
speaker screw and discard (Figure 1).