ETI Solid State Lighting ERHB-YM-SM-W Use And Care Manual

Package contents
Description
Yoke Mount Kit
note: Keep your receipt and these instructions for proof of purchase. To avoid possibility of electrical shock or fire, the installation personnel must
have professional electric knowledge. Please wear gloves to avoid injury before installation. If any smoke or spark of the wire happened, please turn off
the power immediately and notify relevant personnel. Please use listed water proof strain relief bushing when connecting the supply cord to the outlet
box.
WarninG: Shut off the power at the circuit breaker or fuse panel before removing the old fixture, ballast, or fluorescent tubes. Do not use any electric
generator to test the LED light. Please abide by related country, regional and local law and regulations when install this fixture. Please turn off the power
before installation or maintenance. Proper grounding is required to ensure safety. Please check if there is any damage during shipping. If so, please contact
manufacturer timely. Please read the installation instruction carefully to check whether all the accessories are available. After confirmation, install the led
light according to installation steps.
If you are unfamiliar with electrical installations, we recommend you contact a qualified electrician to do the installation.
ceILIng Mount
1 Mark with a mark pen or sharp tool on the mounting surface
and drill.
Align the bracket hole with screw hole and push the fixture to
3
one side and fix it.
After installation, connect the wire of the fixture to the mains
4
according to local wring rules. Ensure the connection is stable,
covered, and protected. By adjusting the brackets screws, user
can adjust 50° to the left or right vertically.
WarninG: Carefully read and understand the information given in this manual before beginning the assembly and installation. Failure to do so could
lead to electric shock, fire, or other injuries which could be hazardous or even fatal. • Ensure the electricity to the wires you are working on is shut off.
Either remove the fuse or turn off the circuit breaker.
• Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
See website for Warranty, Troubleshooting or Care and Cleaning details at www.ETiSSL.com.
Questions, problems, missing parts? Call ETiSSL Customer Service 8 a.m. - 5 p.m., CST, Monday - Friday
Use and Care GUide
Yoke MoUnt kit installation instrUCtions
Quantity
1 Set
10mm
100mm
1-855-etI-ssLI (1-855-384-7754) www.etissL.com
order # 70520101
70518101
70521101
70519101
Yoke Mount Kit
Fix screw into the hole with a hammer.
2
Part # erHB-YM-sM-W
erHB-YM-sM-B
erHB-YM-lG-W
erHB-YM-lG-B