Summary of Contents for ORTEC 4001C
- Page 1 Model 4001C Modular System Bin Operating and Service Manual ® Printed in U.S.A. ORTEC Part No. 485670 1202 Manual Revision C...
-
Page 2: Warranty
In the event ORTEC fails to manufacture or deliver items called for in this agreement or purchase order, ORTEC’s exclusive liability and buyer’s exclusive remedy shall be release... -
Page 3: Table Of Contents
1.3. ORTEC 4001C MODULAR SYSTEM BIN ........ -
Page 4: Safety Instructions And Symbols
SAFETY INSTRUCTIONS AND SYMBOLS This manual contains up to three levels of safety instructions that must be observed in order to avoid personal injury and/or damage to equipment or other property. These are: DANGER Indicates a hazard that could result in death or serious bodily harm if the safety instruction is not observed. -
Page 5: Safety Warnings And Cleaning Instructions
SAFETY WARNINGS AND CLEANING INSTRUCTIONS DANGER Opening the cover of this instrument is likely to expose dangerous voltages. Disconnect the instrument from all voltage sources while it is being opened. WARNING Using this instrument in a manner not specified by the manufacturer may impair the protection provided by the instrument. -
Page 7: Description
Practices” which deal with subsidiary matters in the interest of suggested further compatibility. Included The Model 4001C Bin distributes all dc and ac in the Preferred Practices are standard linear and power from the power supply to the module logic signal parameters which, if observed, allow connectors. -
Page 8: Ortec 4001C Modular System Bin
INSTALLED WIRING All connectors of the Model Power Supply, 15.8 kg (35 lb). 4001C are wired in parallel for +6 V, -6 V, +12 V, - Shipping Model 4001C, 7.3 kg (16 lb); with Model 12 V, +24 V, -24 V, high-quality power return and 4002A Power Supply, 14 kg (30 lb);... -
Page 9: Installation Instructions
The ORTEC Model 4002A or 4002D Power Supply facilitate removal of the bin from the rack and will that usually accompanies the Model 4001C Bin may remove strain from the bin and rack. be used on either 117 V or 230 V, 50 or 60 Hz, input power. -
Page 10: Operating Instructions
4. OPERATING INSTRUCTIONS 4.1. CONTROL PANEL FUNCTIONS 4.2. POWER SUPPLY LIMITATIONS ON-OFF Switch interrupts both sides of the input The available current at each voltage is dependent on the power supply. Since the requirements of power line. DOE/ER-0457T have been changed from time to time, the actual capability of any given power POWER Pilot lamp indicates that ac input power is supply will depend on its date of manufacture. - Page 11 Coaxial *17 - 12 V Coaxial Spare bus Coaxial Reserved bus *41 117 V ac (neutral) Spare *42 High-quality ground Spare Ground guide pin Reserved Pins marked (*) are installed and wired in ORTEC’s 4001A and 4001C Modular System Bins.
Need help?
Do you have a question about the 4001C and is the answer not in the manual?
Questions and answers