Summary of Contents for Samsara 2AIHDMOD1
- Page 1 2AIHDMOD1 User Manual 1) Product Description 2) FCC Statement 3) Industry Canada Statement 501 YORK STREET, SAN FRANCISCO, CA 94110 USA Tel: (415) 985-2400...
- Page 2 1) Product Description The 2AIHDMOD1 is a BLE module designed with the Nordic NRF52832 SoC and Skyworks SKY66112-11 FEM. It incorporates SPI, I2C, and GPIO interfaces for connecting peripherals and sensors 501 YORK STREET, SAN FRANCISCO, CA 94110 USA Tel: (415) 985-2400...
-
Page 3: Important Note
2) FCC Statement Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. - Page 4 End Product Labeling The final end product must be labeled in a visible area with the following: “Contains FCC ID: 2AIHDMOD1”. Manual Information to the End User The OEM integrator has to be aware not to provide information to the end user regarding how to install or remove this RF module in the user’s manual of the end product which integrates...
- Page 5 3) Industry Canada Statement This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the following two conditions: (1) This device may not cause interference; and (2) This device must accept any interference, including interference that may cause undesired operation of the device.
-
Page 6: Note Importante
This device is intended only for OEM integrators under the following conditions: 1) The transmitter module may not be co-located with any other transmitter or antenna. As long as 1 condition above are met, further transmitter test will not be required. However, the OEM integrator is still responsible for testing their end-product for any additional compliance requirements required with this module installed. - Page 7 The OEM integrator has to be aware not to provide information to the end user regarding how to install or remove this RF module in the user’s manual of the end product which integrates this module. The end user manual shall include all required regulatory information/warning as show in this manual.
Need help?
Do you have a question about the 2AIHDMOD1 and is the answer not in the manual?
Questions and answers