Advertisement

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the STEAM BOX MINI 10b asp and is the answer not in the manual?

Questions and answers

Summary of Contents for TECNOVAP STEAM BOX MINI 10b asp

  • Page 2 Pag. 2 TECNOVAP 09/22...
  • Page 3 STEAM BOX MINI is also equipped with a separate detergent tank for injecting detergent at 90- 160°C and a overheated water injection system (optional). In other words, to the power of steam, the epitome of eco-cleaning, TECNOVAP has combined a powerful suction unit (optional) which can suck up both solids and liquids.
  • Page 4 Steam…. Danger of scalding under tension or the unit itself Equipment with sound pressure level Danger of scalding!! > 85db Read the operator manual Wear protective gloves. It is compulsory to use ears protective shrouds. Pag. 4 TECNOVAP 09/22...
  • Page 5 Protect the soil, dispose of used oil in compliance with environmental laws. The user may return the appliance for disposal to the retailer when purchasing a new equivalent appliance, on a one-to-one basis. Pag. 5 TECNOVAP 09/22...
  • Page 6 Pag. 6 TECNOVAP 09/22...
  • Page 7 30 mA for 30 ms, or a device that can check the earth circuit.  WARNING. Use a set of connectors, pipes and new seals every time the appliance is connected to the mains water supply Pag. 7 TECNOVAP 09/22...
  • Page 8 20 seconds ON 20 seconds OFF. Do not run the detergent function continuously for more than 2 minutes.  When using detergents (non-foaming for extraction machines), follow the specific instructions given on the original packaging: usually this is 1 litre of detergent for every 10 litres of water (detergent Pag. 8 TECNOVAP 09/22...
  • Page 9  WARNING. In the event of accidental contact with the detergent used, strictly follow the instructions given on the package and the relative safety data sheet.  Wear gloves when using the appliance. Pag. 9 TECNOVAP 09/22...
  • Page 10 2.1 Filter maintenance Remove the filter inside the mains water coupling (2) by gripping the tab in the centre of the filter with a pair of pliers, then clean and replace. Pag. 10 TECNOVAP 09/22...
  • Page 11: Technical Features

    3. TECHNICAL FEATURES FACTORY: TECNOVAP SRL VIA DEI SASSI 1A 37026 PESCANTINA VERONA ITALY Model 10b asp 6b asp 6b bac 3127A10 3127010 3127A60 3127060 3H27A10 3H27010 3H27A60 3H27060 Code 30230B2 3107A1R 310701R 3107A6R 310706R 3H07A1R 3H0701R 3H07A6R 3H0706R Rated Voltage...
  • Page 12 Pag. 12 TECNOVAP 09/22...
  • Page 13 19. Suction unit bin 7. Water tank 20. Hose coupling safety clamp 8. Control panel 21. Female suction hose coupling 9. Steam coupling 22. Suction unit power cable 10. Detergent tank drainage cap 11. Water tank drainage cap Pag. 13 TECNOVAP 09/22...
  • Page 14 Pag. 14 TECNOVAP 09/22...
  • Page 15 5. Main switch 13. Boiler drainage key Bacchus tools - optional 60) Electrical/water steam connector 61) Hose/system quick-fit connector 62) Steam connector Garolla fitting 63) System overpressure safety valve 64) Garolla fitting 65) Safety pressure switch Pag. 15 TECNOVAP 09/22...
  • Page 16 Pag. 16 TECNOVAP 09/22...
  • Page 17 76) Steam/suction lance Steam ready light 36) Steam/steam-suction hand grip 77) Inserts holder brush 37) Steam hose connector jack 78) Inserts locking lever 37A) Connector jack locking button 79) Squeegee/bristle insert 38) Male suction hose 80) Squeegee/squeegee insert Pag. 17 TECNOVAP 09/22...
  • Page 18 Pag. 18 TECNOVAP 09/22...
  • Page 19 37) Steam hose connector jack /bristle insert Squeegee 37b) Steel cord insert Squeegee squeegee Male suction hose 81) Industrial steam/suction brush 39) Extension tube 82) Stainless steel accessory for upholstery 40) Block button accessories 41) Safety fastening knob Pag. 19 TECNOVAP 09/22...
  • Page 20 Pag. 20 TECNOVAP 09/22...
  • Page 21 71) Steam lance 72) Rectangular brush 36) Steam/steam-suction hand grip 73) Cloth holder 37) Steam hose connector jack 74) Triangular brush 37b) Steel cable 39) Extension tube 480mm 40) Block button accessories 41) Safety fastening knob Pag. 21 TECNOVAP 09/22...
  • Page 22 Pag. 22 TECNOVAP 09/22...
  • Page 23 36) Steam/steam-suction hand grip 50) Steel wool pad 37) Steam hose connector jack 71) Steam lance 37A) Connector jack locking button 72) Rectangular brush 39) Extension tube 73) Cloth holder 40) Block button accessories 74) Triangular brush Pag. 23 TECNOVAP 09/22...
  • Page 24 Pag. 24 TECNOVAP 09/22...
  • Page 25 86) 145-mm bristle/squeegee inserts 34) Overheated water delivery button (optional) 87) Window cleaning steam/suction nozzle 34A) Overheated water indicator light 88) Steam lance 35) Steam ready indicator 89) Suction nozzle 36) Steam/steam-suction hand grip 37) Steam hose connector jack Pag. 25 TECNOVAP 09/22...
  • Page 26 Pag. 26 TECNOVAP 09/22...
  • Page 27 /bristle insert Squeegee 37a) Steam hose locking lever insert Squeegee squeegee 38) Male suction hose 81) Industrial steam/suction brush 39) Extension tube 82) Stainless steel accessory for upholstery 40) Block button accessories 41) Safety fastening knob Pag. 27 TECNOVAP 09/22...
  • Page 28 Pag. 28 TECNOVAP 09/22...
  • Page 29 96) Stainless-steel floor scrubber brush 97) Flat nozzle w/scraper 98) Stainless-steel brush T50 99) Flat nozzle 10mm 30) Steam delivery lever 33) Overheated water injection button 34) Detergent delivery button (intermittent) 37) Steam hose connector jack Pag. 29 TECNOVAP 09/22...
  • Page 30 LED stops flashing and stays on. Mains water Water being delivered from the mains water supply, the LED ON continuously indicates that the water inlet is open. Pag. 30 TECNOVAP 09/22...
  • Page 31 Steam activation buttons/indicators: minimum - medium - maximum. Pressure/temperature display. Shows the “total working hours” counter memory (C1) (hour counter/totaliser). Shows the “partial hours” counter memory, this counter can be reset by the user. Pag. 31 TECNOVAP 09/22...
  • Page 32 (h) The appliance is fitted with a system to protect against thermal shocks. If there is no water in the boiler, the system automatically disables the power supply to the heating elements; this situation is indicated by the flashing LED on the “boiler” button . This system may Pag. 32 TECNOVAP 09/22...
  • Page 33 Hold this button down until detergent flows out of the accessory. 4) The detergent is now triggered, and the appliance is ready for use Pag. 33 TECNOVAP 09/22...
  • Page 34 Inserts holder brush (77): with relative inserts (79 or 80). The inserts are fitted by moving the locking levers (78) inwards (OPEN position), pushing the inserts upwards and then moving the locking levers outwards (BLOCK position). Afterwards fit the brush to the hand grip or the extension tube/s (39) (one or both) and Pag. 34 TECNOVAP 09/22...
  • Page 35 “steam presence” LED is on. Warning!! The button on the lance releases overheated water under pressure at a temperature which, depending on the model, can reach 180°C, be very careful not to press this accidentally and make sure Pag. 35 TECNOVAP 09/22...
  • Page 36 Both the detergent and the overheated water function must be run at intervals (e.g. 20 seconds on 20 seconds off), neither function works continuously. The detergent and/or overheated water (optional) are delivered only if the steam outlet is active and the “steam presence” LED is on. Pag. 36 TECNOVAP 09/22...
  • Page 37 The detergent and/or overheated water (optional) are delivered only if the steam outlet is active and the “steam presence” LED is on. Both the detergent and the overheated water (optional) function must be run at intervals (e.g. 20 seconds Pag. 37 TECNOVAP 09/22...
  • Page 38 (Repeat the operation in sequence to deactivate it). Using the keys, select the quantity of steam you wish to use on start-up (the selected Pag. 38 TECNOVAP 09/22...
  • Page 39: Boiler Maintenance

    Star) on the hand grip by pressing the safety button (30 on July, Radames, Star and Geyser) to bleed out any air in the empty boiler. Wait for the recharge cycle to be completed (approximately 3 min.). Pag. 39 TECNOVAP 09/22...
  • Page 40 Geyser) located on the hand grip and then act on the button on the control panel to activate the detergent pump. Hold this button down until detergent flows out of the accessory. The detergent is now triggered, and the appliance is ready for use Pag. 40 TECNOVAP 09/22...
  • Page 41: Accessories Maintenance

    6.4. Accessories maintenance Grease the joints of the extension pipes and accessories when required. Pag. 41 TECNOVAP 09/22...
  • Page 42 Flashing light Mains water protection on. Check the coupling (2) pressure and water. Remove and clean the filter (3) inside the mains water coupling. (see section 2.1). Pag. 42 TECNOVAP 09/22...
  • Page 43 Wait for the pressure to stabilise (2-3 minutes) and internal depression, which when switched back on the noise stops. causes vibrations. The accessories don’t fit perfectly. The joints and snap-on couplings are dirty. Clean and lubricate the joints on the accessories. Pag. 43 TECNOVAP 09/22...
  • Page 44: Declaration Of Conformity

    EN 61000-3-2 EN 61000-3-3 Il fascicolo tecnico è stato emesso ed archiviato presso Tecnovap S.r.l. con sede in Via dei Sassi, 1a Pescantina (VR) Italy. (The technical dossier was issued and filed at Tecnovap S.r.l. with registered office in Via dei Sassi, 1a Pescantina ,VR - Italy.)
  • Page 45: Routine Maintenance

    Routine Maintenance Working Hours Frequency Note Generator Intervention Pag. 45 TECNOVAP 09/22...
  • Page 46: Extraordinary Maintenance

    Extraordinary Maintenance Working Hours Date of Description of maintenance, components replaced etc. Generator Maintenance Pag. 46 TECNOVAP 09/22...
  • Page 47 Pag. 47 TECNOVAP 09/22...
  • Page 48 THE MANUFACTURER RESERVES THE RIGHT OF TECHNICAL AND STRUCTURAL MODIFICATIONS AS WELL AS IMPROVEMENTS WITHOUT PRIOR NOTICE. Tecnovap S.r.l. – Via dei Sassi 1/a 37026 Pescantina, Verona – Italy +390456767252 – info@tecnovap.com – www.tecnovap.it Pag. 48 TECNOVAP 09/22...

Table of Contents