Page 1
PE51 HURLEY 3 STATION METAL SWING SET OWNER'S MANUAL WARNING! The disassembled product may contain small parts which pose a choking hazard to children under 3. IMPORTANT: This product may contain sharp points and small parts prior to assembly. The owner’s manual contains safety, assembly, use and maintenance instructions. This product must be assembled by an adult who has read and understood these instructions.
TABLE OF CONTENTS GENERAL SAFETY INSTRUCTIONS DANGER FOR CHILDREN RISK OF INJURIES PRODUCT DAMAGE ASSEMBLY ADVICE SAFETY INSTRUCTIONS ASSEMBLY INSTRUCTIONS MAINTENANCE CLEANING WARRANTY...
1 GENERAL SAFETY This product is intended for indoor and outdoor, domestic use only. Do not exceed the intended weight limit Weight Limits: Swing: 50kg; Glider: 100kg Maximum Fall Height: 1.83m 1.1 DANGER FOR CHILDREN WARNING! No eating while using the product ...
1.3 PRODUCT DAMAGE Do not make alterations to the product. Only use original spare parts. Qualified technicians should only carry out repairs – improper repairs can lead to danger for the user. Use this product only as described in this manual. ...
Page 5
The product must always be used in a well-lit area. Do not place anything under the product. Use gloves during assembly and disassembly. Outdoor products should be equipped with a device that in strong wind conditions avoid displacement due to wind (e.g.
2 SAFETY INSTRUCTIONS The safety instructions of the product should always be considered and obeyed. Using the product may result in permanent injury such as paralysis, or even death. Falling off the product may lead to injuries, particularly to the back, neck or head. ...
Page 8
For the supervisor: The supervisor’s role is to make sure users are aware of all safety precautions and that these precautions are enforced. When a supervisor is not available, the product may be disassembled or covered to limit access. WARNING! Do not allow children to twist swing ropes or loop them over the top bar.
ASSEMBLY INSTRUCTIONS Swing Seat x 2 Upper leg x 4 Lower leg x 4 Top Bar A x 1 Top Bar B x 1 Sidestay x 2 Glider Upright A x 2 Glider Upright B x 2 Glider Seat Tube x 2 U Bolt x 1 Glider Bracket x 1 Frame Bracket x 2...
Page 10
Top Bar B M8 x 55mm M8 x 2 Top Bar A Bracket M8 x 65mm Bracket M8 x 4...
Page 11
M8 x 4 M8 x 55mm Upper Leg Upper Leg M8 x 55mm M8 x 4 Do not fully tighten bolts until frame is fully Upper Leg assembled. Upper Leg...
Page 12
M8 x 2 Sidestay M8 x 55mm Lower Leg Lower Leg M8 x 55mm M8 x 2 Sidestay Lower Leg Lower Leg Check all bolts are securely fastened to ensure frame stability.
Page 13
M8X55mm 2PCS M6x30mm M6X35mm 4PCS 8 X 85mm 2 PCS M6 x 35mm x 2...
Page 14
M8 x 4 Can be adjusted to distance between swing seat and ground. Minimum distance 35cm...
RECOMMENDATIONS: The play structure must be securely assembled. For safety reasons, the cement cubes must be poured 5cm below ground level, at the frame’s outer angles. The play structure must not be installed directly on cement, asphalt, or any other hard surface.
4. If your play structure is disassembled, be sure to clearly mark any attached metal plates to prevent accidents. Check all bolt covers and sharp edges and replace them if necessary. 5. Check all moving parts including swing seats, ropes, cables and chains for wear, rust or other deterioration.
Need help?
Do you have a question about the PE51 HURLEY and is the answer not in the manual?
Questions and answers