How To Construct A Devicenet Network Using Rtu-Dnet; How To Construct Devicenet By Rtu-Dnet; How To Configure Network By Devicenet Network Configuration Tool - Delta Electronics RTU-DNET Applications Manual

DeviceNet Remote I/O Communication Module RTU-DNET
5

How to Construct a DeviceNet Network Using RTU-DNET

In this section, we will explain how to configure RTU-DNET and the I/O mapping relation between RTU-DNET
and DVPDNET-SL by an application example.

5.1 How to Construct DeviceNet by RTU-DNET

1. The DeviceNet network
2. Set up DVPDNET-SL and RTU-DNET according to the table below.
DVPDNET-SL
3. Pleae check if all Slim DI/DO extension units, special modules and RTU-DNET are working normally, if the
wiring of the entire network is correct, and if the power supply in DeviceNet is normal.

5.2 How to Configure Network by DeviceNet Network Configuration Tool

1. Configuration of RTU-DNET
(1) Open DeviceNetBuilder software, as below:
22
DVPDNET DVP28SV
RUN
STOP
Master
DeviceNet
Module
RTU-DNET
DVPDNET-SL
DVP28SV
network configuration tool
Node address
1
2
DeviceNet
Baud rate
500 kbps
500 kbps
DVP-PLC Application Manual