Configuration When The Remote Gateway Uses A Dynamic Ip Address; Configuration Of The Wrv200; Configuration Of The Rv082 - Linksys WAP54GP - Wireless-G Access Point User Manual

Appendix E
Configuration when the Remote Gateway
Uses a Dynamic IP Address
This example assumes the Remote Gateway is using a
dynamic IP address. If the Remote Gateway uses a static
IP address, refer to "Configuration when the Remote
Gateway Uses a Static IP. "
RV082
Dynamic IP: B.B.B.B with
Domain Name: www.abc.com
LAN: 192.168.1.1
Gateway-to-Gateway IPSec VPN Tunnel - Remote Gateway Using
Dynamic IP
NOTE:
Each computer must have a network
adapter installed.

Configuration of the WRV200

Follow these instructions for the first VPN Router,
designated WRV200. The other VPN Router is designated
the RV082.
1. Launch the web browser for a networked computer,
designated PC 1.
2. Access the web-based utility of the WRV200. (Refer
to "Chapter 5: Configuring the Wireless-G Router" for
details.)
Click the VPN tab.
3.
Click IPSec VPN.
4.
For the IPSec VPN Tunnel setting, select Enable.
5.
6. Enter a name in the Tunnel Name field.
For the Local Secure Group Type, select Subnet. Enter
7.
the WRV200's local network settings in the IP Address
and Mask fields.
Wireless-G VPN Router with RangeBooster
8.
WRV200
9.
WAN: A.A.A.A
LAN: 192.168.5.1
10.
11.
12.

Configuration of the RV082

Follow similar instructions for the RV082.
1.
2.
3.
4.
5.
6.
7.
Gateway-to-Gateway VPN Tunnel
WRV200 IPSec VPN Settings
For the Remote Secure Group Type, select Subnet.
Enter the RV082's local network settings in the IP
Address and Subnet Mask fields.
For the Remote Secure Gateway Type, select FQDN.
Enter the RV082's domain name in the field provided.
In the Key Management section, select the appropriate
encryption, authentication, and other key management
settings.
In the Preshared Key field, enter a string for this key, for
example, test.
WRV200 Key Management Settings
Click Save Settings and proceed to the next section,
"Configuration of the RV082. "
Launch the web browser for a networked computer,
designated PC 2.
Access the Web-based Utility of the RV082. (Refer to
the User Guide of the RV082 for details.)
Click the IPSec VPN tab.
Click the Gateway to Gateway tab.
Enter a name in the Tunnel Name field.
For the VPN Tunnel setting, select Enable.
The WAN IP address (B.B.B.B) of the RV082 will be
automatically detected.