Indicators Status Description Steady on Normal. RUN(Operation) Blinking Starting up. NET(Network) Steady on Connected to network. Steady on No disk; or disk is abnormal. HD(Hard disk) Blinking Reading or writing data. Interfaces Interface Description Interface Description Network interface 1 Audio out ①...
HDD Installation 3.2.1 Remove Upper Cover 1. Loosen the screws on the upper cover. 2. Slide the upper cover backward, then lift it up to remove the cover. 3.2.2 Install Disks 1. Loosen the screws of the mounting plate on the side panels. 2.
Power cable Data cable 5. Put the cover back in place, and secure it and the mounting plates with screws. Startup and Shutdown Make sure the cables are connected correctly and the device is grounded properly. Use a power supply that meets requirements. Startup Connect the device to power to start the device.
NOTE! After the device is added, if wrong username or password message shows in the preview window, click in the window toolbar and enter the correct username and password. 5.1.2 Custom Add 1. Right click in the preview page, click Menu > Camera > Camera. 2.
Page 6
Disclaimer and Safety Warnings Copyright Statement No part of this manual may be copied, reproduced, translated or distributed in any form or by any means without prior consent in writing from our company (referred to as us hereafter). The product described in this manual may contain proprietary software owned by our company and its possible licensors.
Page 7
recommendations in this manual are presented without warranty of any kind, expressed or implied, including, but not limited to, merchantability, satisfaction with quality, fitness for a particular purpose, and noninfringement. ⚫ Users must assume total responsibility and all risks for connecting the product to the Internet, including, but not limited to, network attack, hacking, and virus.
Page 8
⚫ Multicast: Multicast is intended to transmit video to multiple devices. If you do not use this function, it is recommended you disable multicast on your network. ⚫ Check logs: Check your device logs regularly to detect unauthorized access or abnormal operations. ⚫...
Page 9
FCC Statements This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Caution: The user is cautioned that changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
Need help?
Do you have a question about the M-NVR-32CH-4 and is the answer not in the manual?
Questions and answers