Viking DDWB301CRSS Installation Instructions

INSTALLATION
INSTRUCTIONS
SPHKDS DESIGNER SERIES
SIDE PANEL HARDWARE KIT
For Use with Designer Series
Built-In Refrigerators/Wine Cellars
Retain for Future Reference
IMPORTANT - PLEASE READ AND FOLLOW
•
These instructions are to be used in conjunction with the refrigerator/wine cellar installation instructions supplied with the product.
•Before beginning, please read these instructions completely and carefully.
•Do not remove permanently affixed labels, warnings, or plates from the product. This may void the warranty.
•Please observe all local and national codes and ordinances.
•The installer should leave these instructions with the consumer who should retain for local inspector's use and for future
reference.
PARTS INCLUDED
(2) Z-Brackets
(32) 8-18 x 1/2" Phillips head screws

Installation Instructions

TO INSTALL (Refer to drawings on back):
1. Locate the custom wooden side panels.
2. Using the illustrations on the back, attach the Z-Brackets to the custom wooden panels using the 32 supplied
screws.
3. Slide the Z-Brackets into refrigerator/wine cellar side trim and slide panels into place.
4. NOTE: Adding 3/4" (1.9 cm) side panels adds an additional 3/4" (1.9 cm) to the overall width of the product for
each side panel used.
VIKING RANGE CORPORATION
111 FRONT STREET
GREENWOOD, MISSISSIPPI (MS) 38930 USA
REQUIRED TOOLS
Phillips head screwdriver
(662) 455-1200