Techly I-WL-CPE530 Manual

EN - 1
POINT-TO-POINT CPE
Dear Customer
Thank you for purchasing this product. For optimum performance and safety, please read these
instructions carefully before connecting, operating or adjusting this product. Please keep this
manual for future reference.
IMPORTANTI INFORMAZIONI SULLA SICUREZZA
INTENDED USE
We do not permit using the device in other ways like described in this user's manual. Not
attending to these regulations and safety instruction might cause fatal accidents, injuries,
and damages to persons and property. The manufacturer/supplier assumes no liability for
damages caused by failure to comply with the intended use.
C A U T I O N
RISK OF ELECTRIC SHOCK
DO NOT OPEN
mains and other equipment if a problem should occur. Do not expose the product to water
or moisture.
• Your product is not a toy and is not meant for children, because it contains small parts which
can be swallowed and can injure when used inappropriately!
• Please install the system and devices attached to it in a way that persons cannot be injured,
or objects not be damaged for example by dropping or stumbling.
• Please remove the packing materials, because children may cut themselves on them while
playing. Furthermore, there is a risk of swallowing and inhalation of incidentals and insulating
material.
• Do not install the product at places subject to vibration, or oscillation
• Do not modify and alter the product and any accessories! Do not use any damaged parts.
• Keep enough space around all devices for a good ventilation and free motion and to avoid
damages.
• Keep distance from flammable and explosive devices.
WWW.TECHLY.COM
To reduce risk of electric shock, this
product should ONLY be opened by an
authorized technician when service is
required. Disconnect the product from
POE CONNECTION
Cat5 Ethernet Cable
The network cable crystal head
adopts 568B standard
DEFAULT CONFIGURATION
Default IP Master: 192.168.2.66/24 - Slave: 192.168.2.67/24
Account
admin
Password
admin01
FEATURES
Working frequency
5.150GHz-5.850GHz
TX power
<29dBm (Based on region regulation)
Antenna gain
15dBi
Power supply 12VDC, 24 V PoE
Power consumption <20W
FAST PAIRING
MASTER AND SLAVE BRIDGE CONFIGURATION
Set one bridge to Master by switching the button to M, another bridge to Slave by switching the
button to S.
POINT TO POINT ONE-KEY PAIRING
Press Master bridge RST button for 1-3 seconds and release. In 1 minute, press Slave bridge RST
button for 1-3 seconds and release. Two bridges will pair in 2 minutes.
Pairing complete within 2 minutes
Press RST and release on M,
then press RST and release on S
MASTER
POINT TO MULTI-POINT PAIRING
Press Master bridge RST button for 1-3 seconds and release. In 1 minute, press Slave bridge RST
button for 1-3 seconds and release (repeat this operation to pair more Slave bridges ). Master
and Slave bridges will pair in 2 minutes.
Remarks: When adding new Slave Bridge, current connection will disconnect.
POINT-TO-POINT CPE
Power cord type is based on region
SLAVE