Summary of Contents for Hydro ALUMAX 340D Series
- Page 1 INSTALLATION INSTRUCTIONS 340 D / 350 D SERIES FRAMELESS BYPASS BATH ENCLOSURES www.alumaxshowerdoor.com G03711139 2-6-25 Copyright © Hydro Extrusion USA, LLC 2021. All rights reserved.
- Page 2 Three-Year Limited Residential Warranty Alumax Bath Enclosures by Hydro is pleased to warrant to its dealers and residential customers that the products supplied by it shall be free from defects in material and workmanship for three (3) years from purchase of the product, provided they are installed and maintained according to the manufacturer’s recommended practices and installation instructions.
-
Page 3: Before Beginning Installation
!WARNINGS! Alumax Bath Enclosures by Hydro are intended to be installed by experienced installers. If you need assistance with installation, or locating an experienced installer, contact Alumax Consumer Service at 800-643-1514 or go to our website at www.alumaxbathenclosure.com to access our “dealer locator”. Ensure that the bath enclosure is installed appropriately. - Page 4 Page 4...
- Page 5 Vinyl Anti-Jump Installation V-243 SC-614 Anti-Jump 340D / 350D Header Insert Header When installing the vinyl anti-jump into a new unit it is easiest to slide the vinyl into the end of the header before it is mounted to the frame. There are two 6 in pieces and a 12 inch piece.
- Page 6 Measure the wall-to-wall opening along the center of the tub rim. Cut the tub track [A] 1/16" short of this dimension. An inexpensive miter box available at your hardware store will help you get clean square cuts. If the vinyl silencer [R] is separate from the tub track [A] slide the silencer into the slot in the tub track.
- Page 7 Replace one wall jamb [B] and attach with a #8 x 1-1/2” truss head screw [D] inserted through the middle hole. Slip two bumpers [E] over two #8 x 1-1/2” truss head screws and install in the top and bottom holes. Check for plumb and tighten the screws.
- Page 8 Locate the four, large hole, plastic washers [J] and place them over the threads and flush with the four end caps [I]. Next, place the four glass inserts [L] onto the four end caps [I] and flush with the plastic washers [J]. In step 6 the interior and exterior panels were determined by setting the orientation of the hanger brackets [H].
- Page 9 Lift the interior glass panel into position with the rollers engaging the groove in the header [F]. Repeat for the exterior panel. If panels are not parallel to their respective wall jambs, remove and adjust the rollers up or down in their slots to compensate. Locate the nylon bottom guide [O] in the middle of the tub track [A] with the glass panels in the posi- tion shown.
Need help?
Do you have a question about the ALUMAX 340D Series and is the answer not in the manual?
Questions and answers