Creative Solutions Bradford PP210 Installation Instructions

The Bradford Mailbox Post Kit – Installation Instructions
WARNING: CHECK FOR UNDERGROUND CABLES OR PIPES; COMPLETELY READ OVER INSTRUCTION SHEET BEFORE BEGINNING PROJECT.
RECOMMENDED TOOLS & SUPPLIES: POST HOLE DIGGER, LEVEL, SCREWDRIVER, AND 4 X 4 (48" in length) TREATED PINE POST (NOT INCLUDED).
STEP 1 (Fig 1): Determine location for Mailbox. Using post hole digger, dig a hole 18 inches in depth. Install treated pine post burying 18 inches of the post in
the ground - leaving 30 inches of the post above the ground. Use level to insure treated pine post is in correct vertical position. Stabilize the treated pine post by
firmly tamping down loose soil around post base. Slide Mailbox Post section over 4x4 treated pine post.
STEP 2 (Fig 2): Secure the Mailbox Post section to the 4x4 treated pine post using the (4) 12 x 1 screws included in the kit. Use locations shown in Fig 2 for
correct screw placement.
STEP 3 (Fig 3 & Fig 4): Attach Mounting Bracket to underside of Mailbox using the (4) 10-24 screw and nut sets included in the kit as shown in Fig 3 & Fig 4. Also
included in the kit are four spacers that will be beneficial when mounting a "larger" size mailbox to the Mounting Bracket (see Fig 3). Mounting a "standard"
size mailbox requires no spacers (see Fig 4).
(Fig 1) (Fig 2) (Fig 3) Image below shows
mounting of large mailbox
Model PP210
(Fig 4) Image below shows
mounting of standard mailbox