GAIM GutterGuard Assembly And Installation Instructions

l . Fold the sides down;
snap to bottom
l. Remove tabs on the
side of the
Wedge.
Assembly and Installation Instructions
CAUTION: USE EXTREME CARE WHEN
WORKING ON OR NEAR ROOFLINE
2. Fold end down: snap
sides and bottom. Prior
to installation, remove all
debris from your entire
gutter and downspout
system
2. Insert tabs into
3. Connect the two
holes on the back of using the tabs from the first
the and insert into the second.
Wedge
3. Place the in
Wedge
the gutter with the oval
ring in the downspout
opening, point with sloped
end facing the oncoming
water.
Wedges
Thank you for purchasing the Wedge
Downspout Gutter Guard, the most
economical Made In U.S.A. gutter
guard solution.
The Wedge fits into standard gutters
with a minimum width of 2.7" (7 cm)
with a 2" x 3" downspout opening.
Videos and more info available:
THEWEDGEGUTTERGUARD. COM
4. Remove the oval ring from one of
the Wedges. Place the two Wedges
in the gutter with Wedge with the
oval ring still attached into the
downspout.