Introduction Introduction Thank you for purchasing a Puretec PTE80 Water Filter Monitor. The Puretec PTE80 measures TDS levels in two different water lines, such as tap water and filtered water, at any time. It is designed to monitor if a filter cartridge , resin cartridge or membrane is functioning effectively.
Parts Per Million (equivalent to mg/L) Care & Maintenance There are only a few things to remember when caring for your PTE50 unit; • Never touch the sensor pins, as the oils on your skin may affect the TDS measurement.
Installation Installation The PTE50 can be configured in a variety of ways, depending on your needs. Typically, the IN line (line 1) is connected to the source (tap) water, and the OUT line (line 2) is connected to the product (filtered) water.
(if calibrating to still (not flowing) solution, calibrate to 3% above the level of the calibration solution. This will accommodate for the lack of flowing water, which the monitor is programmed for. For example; if the calibration solutionis 342 ppm, calibrate to 352 ppm). PTE50 User Guide...
Need help?
Do you have a question about the PTE50 and is the answer not in the manual?
Questions and answers