Download Print this page

Millennium Q-200 Assembly Instructions

Buck hut upgrade

Hide thumbs Also See for Q-200:

Download this manual

MILLENNIUM Q-200 Buck Hut Upgrade

ASSEMBLY INSTRUCTIONS

Assembly needs to be done with the cover off the Buck Hut

NOTE: Nothing will change on the door side of the Buck Hut.

STEP 1: Place shooting rail A as far down on the upright as possible as

seen in Image 1.

STEP 2: Remove bolts at the top and bottom of uprights B and remove

uprights B along with shooting rails C all at once and discard.

(IMAGE 1)

Need help?

Do you have a question about the Q-200 and is the answer not in the manual?

Page 1 MILLENNIUM Q-200 Buck Hut Upgrade ASSEMBLY INSTRUCTIONS Assembly needs to be done with the cover off the Buck Hut NOTE: Nothing will change on the door side of the Buck Hut. STEP 1: Place shooting rail A as far down on the upright as possible as seen in Image 1.
Page 2 STEP 3: Remove bolt (E) on the top of uprights (D), do not remove the bottom bolts as the bottom section will remain in place. Remove the top section of upright (D). You will need to push up on the roof frame and pull the upright toward you to get it lose from its top attachment point.
Page 3 STEP 4: Assemble the two new uprights supplied using ¼” x 1” bolt and lock nut as seen in Image 3. The bolt needs to be very tight but do not crush the tubing. (IMAGE 3) STEP 5: Place the new shooting rails on the (D) upright by sliding them on from the bottom up.
Page 4 Now you are ready to install the new cover. ( IMAGE 5) If you have any questions or concerns contact: Millennium Outdoors support@millenniumstands.com 601-932-5832.