Related Manuals for Lusso WALL HUNG
Summary of Contents for Lusso WALL HUNG
- Page 1 VANIT Y UNIT WAL L H UN G INSTA LL AT I O N A ND CARE G UI D E Please retain for future reference...
-
Page 2: Required Installation Tools
INTRODUCTION Thank you for purchasing a wall hung vanity unit from Lusso. Please read this guide carefully before installing, using and cleaning your vanity unit, and retain it for future reference. If you have any queries in relation to your purchased product or this guide, please contact our Customer Service team on 020 3370 4057. -
Page 3: Before Installation
BEFORE INSTALLATION We recommend that all vanity units are installed by a fully qualified plumber. Prior to installation, please ensure that the installation area is suitably ventilated, and installation surfaces are prepared and completed in advance. Failure to do so will void your product warranty. -
Page 4: Installation Steps
INSTALLATION STEPS On a pre-cladded surface, install an in-wall horizontal noggin during the framing stage, factoring in the desired height of the vanity unit (including the vanity basin). Please note that this step is only applicable to hollow walls, and should be disregarded for concrete walls. - Page 5 Wall stud Post-cladding in wall horizontal noggin (*See below) Wall stud Compressed Compressed Plaster *Install in wall Plaster horizontal noggin at framing stage factoring in desired Use spirit level to mark Finished height of vanity, including vanity Finished holes for mounting brackets, Surface basin (pre-cladding stage) Surface...
- Page 6 Non-Acidic Kitchen & Bathroom Silicone Non-Acidic Kitchen & Bathroom Silicone...
- Page 7 DRAWER HINGE ADJUSTMENT AND REMOVAL QUICK ASSEMBLY TROUBLESHOOTING The drawer slides unsteadily - what should I do? This is usually caused by debris in the mechanism. Carefully remove any debris, and ensure that the drawer runners are covered during assembly. The drawers do not fully close - what is the issue? To address this, you should correct the front and back assembly position of the drawer slides.
- Page 8 DTC DRAWER/HINGE INSTALLATION Move out the adjusting part and fix Fix the slide onto the cabinet. the locking device onto the drawer bottom. Put the adjusting part back and tighten the screws. Lay the drawer bottom onto the slide then push the drawer into the cabinet.
- Page 9 DTC DRAWER/HINGE ADJUSTMENT/REMOVAL ADJUSTMENT ADJUSTMENT Up and down adjustment. Side adjustment. ADJUSTMENT REMOVAL Pull-out Hold the handle Depth Adjustment. REMOVAL Hold the handle and pull-out the drawer.
- Page 10 UNIHOPPER GENERAL DRAWER Insertion. Slide in. ADJUSTMENT REMOVAL Down...
- Page 11 UNIHOPPER QUICK ASSEMBLY DRAWER “Click” ADJUSTMENT REMOVAL...
-
Page 12: Care Instructions
Do not use abrasive cloths or cleansing products. Do not use strong detergents, ammonia-based products or bleaches. Avoid contact with prolonged condensation and heavy water spillages. Go to Lusso.com to activate your guarantee. Customer Care: 020 3370 4057 International: +44 20 3370 4057...
Need help?
Do you have a question about the WALL HUNG and is the answer not in the manual?
Questions and answers