Table of Contents
Advertisement
Quick Links
Copyright
Copyright © 2001 by this company. All rights reserved. No part of this publication
may be reproduced, transmitted, transcribed, stored in a retrieval system or
translated into any language or computer language, in any form or by any means,
electronic, mechanical, magnetic, optical, chemical, manual or otherwise, without
the prior written permission of this company.
Disclaimer
This company makes no representations or warranties, either expressed or implied,
with respect to the contents hereof and specifically disclaims any warranties,
merchantability or fitness for any particular purpose.
Further, this company
reserves the right to revise this publication and to make changes from time to time
in the contents hereof without obligation of this company to notify any person of
such revision or changes.
Canadian Department of Communications
Regulatory Statement
This digital apparatus does not exceed Class B limits for radio noise emissions
from digital apparatus set out in the Radio Interference Regulations of the Canadian
Department of Communications.
Le présent appareil numérique n'émet pas de bruits radio-électriques dépassant les
limites applicables aux appareils numériques de la classe B prescrites dans le
Réglement sur le brouillage radioélectrique édicté par le ministère des
Communications du Canada.
FCC Class B Radio Frequency
Interference Statement
Note:
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of FCC Rules.
These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
1.
Reorient or relocate the receiving antenna.
User's Guide
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for BenQ 4012EU
- Page 1 Copyright Copyright © 2001 by this company. All rights reserved. No part of this publication may be reproduced, transmitted, transcribed, stored in a retrieval system or translated into any language or computer language, in any form or by any means, electronic, mechanical, magnetic, optical, chemical, manual or otherwise, without the prior written permission of this company.
- Page 2 Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/television technician for help. Notice 1: The changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
-
Page 3: Safety Instructions
Safety instructions Follow all warnings and instructions marked on the product. DANGER: Invisible laser radiation when open. Avoid direct exposure to beam. Unplug this product from the wall outlet before cleaning. Do not use liquid cleaners or aerosol cleaners. Use a damp cloth for cleaning. Openings in the front panel and the back or bottom are provided for ventilation. -
Page 4: Table Of Contents
Table of Contents USB C .........2 OTICE BOUT SING XTERNAL EWRITER ................2 ATAIN EVICE ERFORMANCE “B ” ............2 REVENT ROM THE UFFER NDERRUN ERROR ...............3 ECOMMENDED YSTEM ONFIGURATIONS ...................4 RODUCT ESCRIPTION ......................4 RONT ......................5 ......................5 ......................6 NSTALLATION ..................6 ARDWARE NSTALLATION ..............8 WRITING SOFTWARE INSTALLATION ..................9... -
Page 5: Notice About Using An External Usb Cd-Rewriter
Notice About Using An External USB CD-Rewriter Maintain The Device Performance If you want to maintain the CD-Rewriter’s better performance, we recommend you connecting only one of the CD-Rewriter to your computer at a time. However, there is an extreme reduction in performance when two or more of fast USB devices (such as CD-ROM, CD-Writer, scanners, printers and hard drive) are used simultaneously. -
Page 6: Performance
Recommended System Configurations The system requirements listed below are recommended for ensuring consistent writing performance. Š Operating system: Windows 98 or higher Š RAM: 32 MB or larger. Š CPU: Pentium 166 MHz or above Š Hard disc drive: Minimum 50 MB of free space for installing software. 750 MB free HD is needed when duplicating a CD through HD (10 MB free space for each minute of recorded music). -
Page 7: Product Description
Product Description Front View 1. Open/Close button: Open and close for disc loading and removal. Play audio CD and skip one track forward if press again. 2. Play/Skip button: Lights up when data is being read from the disc; flashes 3. -
Page 8: Rear View
Rear View Power switch: turns the CD-Rewriter on and off. USB interface connector: connects the CD-RW drive to the USB cable. Power supply connector Left View Power led: indicates the power supply status User’s Manual... -
Page 9: Installation
Installation Hardware Installation Installation procedure Turn on your computer and enter the Windows 98SE/ 2000/ ME operating system. Connect the AC transformer to the CD-Rewriter and the power outlet. Power outlet Turn on the power. And the power indicator should be on at this time. Off On Power indicator Connect the CD-Rewriter to the PC’s USB slot with a USB cable. - Page 10 Once you finish the above steps, the system will automatically detect the presence of the CD-Rewriter. Please finish the driver’s installation according to the computer’s instruction (the driver software is on the attached 1.44MB disk). After rebooting, the computer system will automatically recognize the CD-Rewriter. (Additional software programs, provided with the product, can be installed.
-
Page 11: Cd Writing Software Installation
CD writing software installation Before you start… Please understand that CD recording is a non-interruptible process. Therefore, a stable recording environment is a must. It is the best condition, if you have a HDD only for CD recording purpose. That is, in this HDD, only Windows 98SE or higher and the necessary software are installed, nothing else. -
Page 12: Operation Instructions
Operation Instructions Load a CD disc Š Press the eject button on the CD-ReWriter front panel and the tray will eject automatically. Š Put the CD disc in the tray with the labeled side up. Š Press the eject button or slightly push on the front of the tray to close the tray. When a CD disc is loaded, you should be able to read files properly on the disc within a program. -
Page 13: Frequently Asked Question (Faq)
Frequently Asked Question (FAQ) The following FAQ’s are the most common problems you may find during installation or regular use. Please review these FAQ’s to have your problem solved. In case you do not find any items that answer your problem, please contact your dealer or technical support. Q: The CD-ReWriter doesn’t show up in My Computer or Explorer. - Page 14 Other Hardware Š Spin-down of CD-ROM drives you're copying data or audio from. Š Slow source devices. Š Source devices that transfer data in bursts. Š Incorrect recorder controller settings. Š Inability of the devices to sync properly. Š Overall system configuration. Š...
- Page 15 Q: Cannot directly copy from one CD to another. Š Some CD-ROM disc will not allow direct copying to the CD-ReWriter or are not capable of digital audio extraction. Š You need to have a supported CD-ROM drive to use as your source. Š...
- Page 16 Q: Can I use hard drive compression software? It is not recommended to use hard drive compression software when CD-ReWriter is installed. CD-R and CD-RW writing program may check free space to estimate needed space. However, due to the hard drive compression software’s compression ratio may vary from time to time.
-
Page 17: Technical Supports
Technical Supports In case you cannot solve the problems by FAQs, contact customer support. Please have the following information ready before you call or email us. It is also helpful to write down any error messages you received. Information In your computer CD-ReWriter firmware version Drive serial number Computer or motherboard brand/model...
Need help?
Do you have a question about the 4012EU and is the answer not in the manual?
Questions and answers