anko SLR-24106 Quick Start Manual

IMPORTANT SAFETY INSTRUCTIONS:
The following safety precautions should always be followed, to reduce the risk of electric shock, personal injury or fire. It is
important to read all of these instructions carefully before using the product, and to save them for future reference or new
users.
1. This product must only be used as intended in accordance with the enclosed operating instructions.
2. If the luminaire stops unexpectedly or appears to malfunction, seek professional advice to rectify the fault or make repairs.
3. Keep the luminaire away from sources of heat, sharp objects or anything that may cause damage.
4. Use only a microfiber and dry cloth for cleaning the product.
5. The light source of this luminaire is not replaceable; when the light source reaches its end of life the whole luminaire shall be replaced.
6.The battery is non-replaceable. DO NOT attempt to replace it.
7.This product is not a toy, keep out of reach of children and pets
8. When using for the first time, place the product in a sunny place for charging for about 13 hours.
9. When the product is not used for a long time, please place the product in a sunny place for charging for 1 day. In order to maintain the
function of the battery, it is better to put it in the sufficient sunlight once a month.
10. The charging time and charging efficiency of solar panels may be affected by weather and installation location. Considering the
conversion rate of solar power generation, if the product is used in good weather, it will increase the charging efficiency and effectiveness.
11. When there is sunlight and other lights, or the power switch is turned off,
the LED light will not be on day and night.
12. The solar lamp should be installed in the place with effective light to ensure
that the solar panel can fully absorb the sunlight, so as to extend the working
time of the solar lamp. Shadows from buildings, trees, walls/hedges and similar
objects should be avoided if possible as these will reduce performance.
13. The angle and light direction of the solar lamp should be adjusted to the
best position, and the recommended height is 2-3m.
14. In winter or short sunshine time, it is recommended to use solar lamp in
mode 1.
15.Some condensate may form inside the unit or solar panel in cold conditions.
This is normal and can be ignored.
16.Outdoor use only.
Product specification
•
Bulb rating: LED Max. 2W
•
Type of Battery: Li-ion 3.7V 1200mAh
• Solar panel charging voltage: 4.5-5V
•
Detective angle: 150°
•
Detective distance: 4 m
• Protection rating: IP44
Remote control parameter
•
2 * 1.5V AAA batteries required (batteries not included).
•
Never mix different types or old and new batteries.
• Do not short circuit supply terminals or dispose of batteries in afire.
• Remove batteries during long period of non-use.
ON: turn on the lighting fixture.
•
OFF: turn off the lighting fixtures.
MODE 1: Human body sensing mode (the light is on when a
personpasses by, and it is off 15 seconds afer the
person leaves) If the detector always detects the
human movement, the light will stay on.
MODE 2: Human body sensing mode + low light mode (the light
will be on when people pass by, and keep 15 seconds
after person leave. Then go into low light mode. And
will be on again when detects person again)
MODE 3: Low light mode (always in low light whatever there
is person or not).
FLASH: Pressing it will enter flash mode.
K: 43543205 T: 70963465
SOLAR MOTION SENSOR
SECURITY LIGHT
SLR-24106
LED Lamp
Remote control
sensor receptor
Infrared motion sensor
Solar panel
ON
Human Body
Sensing Mode
Human Body
Sensing Mode
+
Low Light Mode
ON/OFF Switch
Press the button, Enter mode 1.
Press the button again, Enter mode 2.
Pressing a 3rd time, Enter Mode 3.
Pressing a 4th time will turn off the lights.
OFF
Low Light Mode
Flash Mode
FLASH