• If the power cord is damaged, it must be replaced by a recommended qualified technician in order to avoid a hazard. • HOST recommend that this appliance should be periodically tested (at least annually) by a Competent Person. Testing...
• The appliance is not to be used in locations where flammable vapour or explosive dust is likely to exist. • Do not use in barns, stables and similar locations. • HOST recommend that this product is connected to a circuit protected by an appropriate RCD (Residual Current Device). Installation Note: Ensure the mounting substrate and the fixings used can support the weight of the appliance.
Page 4
Changing the Bulb WARNING: Always turn Off the appliance and disconnect from the power supply before changing the bulb. 1. Remove the collection tray. 2. Lay the appliance face down. 3. Unscrew the two screws holding the safety guard at the rear of the Insect killer [Fig.
Tube has expired Refer to the ‘Changing the Bulb’ section Tube is faulty or has not been fitted correctly Service Should your appliance have a fault, please visit the Service section of the HOST website. Technical Specifications Dimensions Weight Model...
All rights reserved. No part of these instructions may be produced or transmitted in any form or by any means, electronic, mechanical, photocopying, recording or otherwise, without the prior written permission of HOST. Every effort is made to ensure all details are correct at the time of going to press, however, HOST reserve the right to change specifications without notice.
Page 7
DocuSign Envelope ID: 1453E3A2-9407-4FBF-B6EC-92CF7C7DEC0D UKCA Declaration of Conformity {Host} {Host House, Chepstow, NP16 6UP} hereby declare that the equipment is in conformity with the requirements of the following Regulations: Electrical Equipment (Safety) Regulations 2016 Electromagnetic Compatibility Regulations 2016 ...
Need help?
Do you have a question about the HOST0711FS and is the answer not in the manual?
Questions and answers