JVC JY-VS200U - Professional Dv 1-ccd Camcorder User Manual page 6

Display
6e
Power Switch
Speaker
PHONE
(headphone)
connector*
Remote sensor
DISPLAY
PLAY
* Located beneath the cover.
JY-VS200U EN 66-95
Audio Dubbing
Audio Dub
The audio track can be customized only when recorded in
Standby mode
the 12-bit mode (
NOTES:
Audio Dubbing is not possible on a tape recorded in 16-
bit audio, on a tape recorded in the LP mode or on a
blank portion of a tape.
To perform Audio Dubbing while watching on the
television, make connections (
1
MIC (external
microphone
input) connector*
2
3
4
To hear the dubbed sound during playback . . .
.... set "12BIT MODE" to "SOUND 2" or "MIX" in the
NOTES:
Audio dubbing is also possible using an optional
microphone connected to the MIC connector .
Sound is not heard from the speaker during Audio
Dubbing. To hear sound, connect optional headphones
to the PHONE connector.
While an optional microphone is connected, the built-in
microphone is disabled.
When editing onto a tape that was recorded at 12-bit,
the old and new soundtracks are recorded separately .
If you dub onto a blank space on the tape, the sound
may be disrupted. Make sure you only edit recorded
areas.
Stereo
If feedback or howling occurs during TV playback, move
microphone
the camcorder's microphone away from the TV, or turn
down the TV's volume.
If you change from 12-bit to 16-bit in mid-recording
and then use the tape for Audio Dubbing, it is not
effective from the point where 16-bit recording began.
A.DUB
During Audio Dubbing, when the tape moves to scenes
recorded in the LP mode, scenes recorded in 16-bit
PAUSE
audio or a blank portion, Audio Dubbing stops
(
STOP
To perform Audio Dubbing with a video unit connected
to the camcorder's AV connector, first set "S/AV INPUT"
to "ON" in the Menu Screen (
sound from the video unit using optional headphones.
71
pg. 29).
Play back the tape to locate the point where editing
will start, then press PAUSE (6).
While holding A.DUB (e) on the remote control,
press PAUSE (6). "6e" appears.
Press PLAY (4) , then begin "narrating".
Speak into the microphone.
•To pause dubbing, press PAUSE (6).
To end Audio Dubbing, press PAUSE (6), then STOP
(5).
Menu Screen ( pg. 41, 42).
pg. 87).
01.3.12, 7:31 PM
71
EN
pg. 54).
pg. 41). You can hear