Murdock GRC75 Installation Instructions

INSTALi.A TION INSTRUCTIONS,
A- REFER TO DRAWING # 9938-375-,QQ1 TO INSTALL STANDARD
SUPPLIED WALL MOUNTING PLATE UJ.
8- ROUGH-IN WASTE OUTLET (2) AT DIMENSIOJ:l SHOWN FOR
1-1/4" OUTER DIAMETER PLAiJr END P-TRAP �-
C- ROUGH-IN WATER SUPPLY (4) AT DIMENSION SHOWN FOR
THE 1/4" NOMINAL (3/8" o':15'.) x 4" L
CONNECTED TO THE IN-LINE STRAINER
RECOMMENDED ON SUPPLY IS TO BE SUP
D- CAREFULLY REMOVE FIXTURE l6J AND COMPONENTS FROM THE
PACKAGING PREVENTING SCRAltHING AND DAMAGE.
E- REMOVE BOTTOM ACCESS PANEL
TO UNIT. ENSURE PUSHBUTTON
SECURE AND CHECK ALL THE TUB G CONNECTIONS TO MAKE
SURE THEY DID NOT COME LOOSE IN SHIPMENT.
f
G COPPER TUBE
5 PROVIDED. STOP
�
IED BY OTHERS.
i·
ASSEMBLE P-TRAP (3)
8 AND THE BUBBLER ARf"
DECREASE
FLOW
J==_.....;;;;;;;; ........ �;r"'===V
2" 31" 4
51"
2
BACK ROUGH•IN YEW
F- SLIDE FIXTURE OVER STUDS FROM WALL �UNTING PLATE G)
AND SECURE WITH NUTS AND WASHERS ®·
G- MAKE-UP 1-1/4" O.D. WASTE CONNECTION TO P-TRAP @.
H- FLUSH WATER SUPPLY (4) BY OTHERS OF ALL DEBRIS PRIOR
TO CONNECTING TO FIX�E.
I- CONNECT WATER SUPPLY (4) BY OTHERS TO 1/4" NOMINAL
COPPER TUBE INLET. STOP C1N THE SUPPLY IS RECOMMENDED.
J- TEST OPERATION OF BUBBLER BY DEPRESSING BUTTON 18),
ADJUST THE FLOW RATE AS REQUIRED. SEE DETAIL A. CH�K
ALL CONNECTIONS AND WASTE PIPING FOR LEAKS. CORRECT
IF PRESENT.
K- RE-INSTALL BOTTOM ACCESS PANEL (J).
DATE ISSUED
09/27/05
DATE REVISED
03/11/18
INCREASE
FLOW
SLOTTED
SCREWDRIVER
DETAIL A
FLOW ADJUSTIENT
+
�
DRAWING NUMBER
9938•100-001
HOLE