Summary of Contents for Titan Attachments STMPGRNDR24STAN
- Page 1 STANDARD DUTY STUMP GRINDER STMPGRNDR24STAN 124130 Operator’s Manual Read the Operator’s Manual entirely. When you see this symbol, the subsequent instructions and warnings are serious follow without exception. Your life and the lives of others depend on it!
-
Page 2: Important Safety Information
IMPORTANT SAFETY INFORMATION These are common practices that may or may not be applicable to the products described in this manual. DANGER! WARNING! DANGER - Indicates a hazardous Prevent serious injury or death. situation, which, if not avoided, WILL Read and understand this manual before operating result in death or serious injury. - Page 3 IMPORTANT SAFETY INFORMATION These are common practices that may or may not be applicable to the products described in this manual. Avoid Power Lines & Underground Utilities Raised Attachment DANGER! WARNING! Prevent electrocution. Crushing hazard. Death or serious injury can result if equipment Raised, unsupported stump grinder can fall, comes near or contacts power lines.
-
Page 4: Operation
OPERATION Quick-Attach must always be fully engaged Check the surrounding area for and in the locked position. bystanders and clear them before starting the skid steer or attachment. Keep bystanders away from equipment while Before operating the attachment, always in use. visually inspect and verify that the coupler lock pins are fully engaged through the latch Always wear face or eye protection, safety... -
Page 5: Routine Maintenance
ROUTINE MAINTENANCE Replace Cutting Teeth Inspections 1. Support stump grinder to prevent falling. Check hydraulic hoses and fittings daily for 2. Stop skid steer engine and remove key. leaks. Replace hose if worn or damaged. Inspect cutting teeth for damage. Inspect the unit for any buildup of 3. - Page 6 PARTS DIAGRAM / EXPLODED VIEW...
- Page 7 Part No. Ref. Part Description JSG61.13FH Skid steer mount weldment JSG61.20FH Mesh guard GB/T 889.1 Nut M12 GB/T 97.1 Washer 12 GB/T 5783 Bolt M12*35 B-G043290-8 Lock Pin 8 JSG61.18FH JSG61.2TITAN The cover weldment JSG61.19 Relief valve GB/T 70.1 Screws M8*60 JSG61.17 Pin Shaft GB/T 97.1...
- Page 8 GB／T 13871.1 Oil seal(B) 50×80×8 GB/T 93 Washer 12 GB/T 70.1 Screws M12*60 ESG47.9 Bearing 02 GB/T 276 Bearing 61804 ESG47.8 Bearing seat cover GB/T 97.1 Washer 6 GB/T 93 Washer 6 GB/T 5783 Bolt M6*20 GB/T 6182 Nut M16 SSG61.3 Shaft GB/T 97.1...
- Page 9 ACKNOWLEDGEMENT OF RISK AND RELEASE OF LIABILITY The use of any equipment, including this one, involves the potential risk of injury. Apart from any warranty claim that might be presented for a claimed defect in material or workmanship of the product, you accept and assume full responsibility for any and all injuries, damages (both economic and non- economic), and losses of any type, which may occur, and you fully and forever release and discharge Titan, its insurers, employees, officers, directors, associates, and agents from any and all claims,...
- Page 10 NEED HELP? CONTACT US FIRST. 1-800-605-7595 info@palletworks.com www.palletforks.com © 2024 Titan Brands...
Need help?
Do you have a question about the STMPGRNDR24STAN and is the answer not in the manual?
Questions and answers