Page 3
User Manual This manual is subject to update without prior notice. Please refer to the latest version on the official website (www.gdu-tech.com). The whole machine has a one-year after-sales warranty. For specific after-sales policies, please refer to the official website.
Page 4
Introduction The S200 series drones implement advanced flight control algorithms, camera processing algorithms, gimbal stabilization algorithms, and visual AI algorithms. They integrate omnidirectional obstacle avoidance systems, high-precision RTK systems, and visual positioning systems. They boast advanced automatic flight capabilities, such as automatic cruising, AI intelligent identification and tracking, automatic return, and automatic precise landing, as well as visual assisted positioning, visual omnidirectional obstacle avoidance, etc., ensuring safer and more stable flight.
“Power Off” button displayed on the remote control screen to turn off the remote Joystick control; when the remote control is turned on, You can switch flight modes in GDU Flight Ⅱ. press and hold for 8 seconds to force shutdown.
Page 7
24 USB-A interface 14 Photo button Connect to mobile devices, USB card readers, Press to take a photo. etc., or network adapter output. 15 Recording button 25 HDMI interface Start or stop recording. Output HDMI signal to external display. 26 Type-C port 16 Left dial Android system debugging, external expansion Turn to adjust the pitch angle of the gimbal...
Page 8
Prepare the aircraft First use The S200 series drones are in storage state when they leave the factory. Please follow the steps below to prepare the aircraft and remote controller. Prepare the aircraft When using the aircraft for the first time, you need to charge the intelligent flight battery to activate the battery.
Before each flight, be sure to check whether each propeller is installed correctly and firmly. • Please use the propellers provided by GDU-TECH. Propellers of different models cannot be mixed. • Before replacing the propeller, make sure the aircraft power is cut off.
2. Turn on the remote control and aircraft. 3. Run the GDU Flight Ⅱ APP and enter the camera interface. 4. Wait until the aircraft self-check completes. If there is no abnormal prompt in the GDU Flight Ⅱ APP, you can start the motor.
Remove the battery Install the battery Charging 1. Take out the aircraft battery; 2. Input voltage: 17V; 3. Charging time: ≤ 50 minutes. · Running this device in a residential environment may cause wireless interference. Turn on/off the battery To turn on the battery: When the battery is turned off, first short press the battery power button once, the power LED indicator will show a scrolling effect, and then long press the power button for 2 seconds to turn on the battery.
Page 12
Maximum ascent speed 8 m/s Maximum descent speed 6 m/s Maximum horizontal flight speed 21 m/s Maximum tilt angle 35° Maximum wind speed 12 m/s Maximum flight time ≥45 min (long battery life version) Positioning mode Supports RTK or single Beidou GNSS GPS + Galileo + Bei Dou + GLONASS IP protection level...
Page 13
accuracy -20°C to 150°C < (high gain mode) Temperature measurement range 0°C to 550°C (low gain mode) Zoom 32 times Photo resolution 640 × 512 Video resolution 640 × 512@30fps Gimbal Stabilization system Three-axis mechanical gimbal (pitch, roll, pan) Maximum control speed (pitch) ≥...
Page 14
Weight 1050g (without external battery), 1300g (with external battery) Operating temperature -20 - 50°C Intelligent flight battery Capacity 8000 mAh Battery type LiPo 4S Energy 115Wh Charging environment temperature 5℃ - 40℃ Long-endurance intelligent flight battery Capacity 9400 mAh Battery type LiPo 4S Energy 140Wh...
Page 15
device has also been tested against this SAR limit. This device was tested for typical body-worn operations with the back of the This device kept 0mm from the body. To maintain compliance with FCC RF exposure requirements, use accessories that maintain an 0mm separation distance between the user's body and the back of This device.
Need help?
Do you have a question about the S200 Series and is the answer not in the manual?
Questions and answers