EVERSPRING SA206 Manual

SA206 Unet 5.0 Repeater
General Introduction
The SA206 is a signal Repeater to extend the range of U-Net wireless devices. It is
fully compatible with any U-Net 5.0 enabled sensors and Controller.
The Repeater is designed to be installed by a system installer in cases where signal
reception is poor or extended range is required. The Repeater does not alter the
existing binding network between Controller and devices, in fact devices do not
need to be physically removed from their mounting location when adding the
Repeater. This allows the installer to service the user in the shortest time possible
without disrupting to the home interior.
It comes with installer friendly feature such test mode to indicate signal strength
using LED display and audible beeps for areas not in line of sight such as corners.
Powered by backup battery, this allows the Repeater to be easily placed anywhere
while searching for its optimum location.
Main Features:
• Setup by smartphone App, no need for pairing to sensors
• Rechargeable backup battery lasts over 48hrs
• Supports up to 2 level connection
• Test mode with beep sound to indicate signal strength
• Tamper detection
• Low battery alert for backup battery
Product Overview
A B C D
E
F
A. Power LED
B. Alert LED
C. Controller Disconnect LED
D. Factory test LED*
E. RF strength test LED
F. Buzzer
*
for factory use
Rear view with back cover lifted:
G
J
K
M
G. Back cover
H. Tamper switch
I. DC Jack power input
J. Binding button
K. Backup Battery power switch
L. External 12V power input
M. Factory test connector*
*
for factory use
1
H
L
I