This manual and all the contents contained in it are owned by Shenzhen Minewsemi Co., Ltd. and are protected by Chinese laws and applicable international conventions related to
copyright laws.The company has the right to change the content of this manual according to the technological development, and the revised version will not be notified otherwise.
Without the written permission and authorization of the company, any individual, company, or organization shall not modify the contents of this manual or use part or all of
the contents of this manual in other ways. Violators will be held accountable in accordance with the law.
Page 2
Bluetooth PA Module MS88SFA The nRF52833 inthemodule is a cost-effective and low-power loss SOC solution that fit for Bluetooth low-power loss’ application. It owns a RF transceiver of Cortex-M4F ARM core operating at speed of 64Mhz. Besides, it has 512kB FLASH programmer space, 128kB RAM and other matching powerful resources.
Bluetooth PA Module MS88SFA 1 Product introduction MS88SFA is a BLE5.2 PA/LNA module base on highly flexible and very low power-loss nRF52833 SoC. The strong 32-bit ARM CortexTM M4F CPU, 512kB flash memory, 128kB RAM and integrated 2.4GH transceiver inside it providing wonderful solutions for Bluetooth connecting.
Page 6
9 Certification 9.1 CE Certification MS88SFA module is being tested and is expected to be compliant against the EU-Radio Equipment standards. OEM integrator should consult with qualified test house to verify all regulatory requirements have been met for their complete device.
Page 7
The final end product must be label in a visible area with the following Host must Contains FCC ID: 2ABU6-MS88SFA . If the size of the end product is larger than 24x16mm, then the following FCC part 15.19 statement has to also be available on the label: This device complies with Part 15 of FCC rules.
Page 8
Bluetooth PA Module MS88SFA 2.10 Additional testing, Part 15 Subpart B disclaimer The module without unintentional-radiator digital circuit, so the module does not required an evaluationby FCC Part 15 Subpart B. The host should be evaluated by the FCC Subpart B.
Page 9
Bluetooth PA Module MS88SFA user's authority to operate this equipment. If the size of the end product is smaller than 8x10cm, then additional FCC part 15.19 statement is required to be available in the users manual: This device complies with Part 15 of FCC rules.
Page 10
Bluetooth PA Module MS88SFA -- Increase the separation between the equipment and receiver. -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -- Consult the dealer or an experienced radio/TV technician for help.
Page 11
Bluetooth PA Module MS88SFA Refer to IPC/JEDEC standard; Peak TEMP<260℃;Times:≤2 times,suggest only do once reflow soldering on module surface in case of SMT double pad involved. Contact us if special crafts involved. 2) Suggesting to make 0.2mm thickness of module SMT for partial ladder steel mesh, then make the opening extend 0.8mm...
Page 14
Bluetooth PA Module MS88SFA 11.2 Part number description Each module is with different code no. To define whether with 32.768k or not, with on-board antenna or external antenna, the code no. will be marked on the metal shield, description as below:...
Bluetooth PA Module MS88SFA Output External Packing Mode Reel tray Tray pallet 12 Quality Disclaimer The factory has passed the ISO9001 quality management system, ISO14001 environmental management system and OAHS18001 occupational health and safety assessment . Each product has been rigorously tested (transmission power test, sensitivity test, power consumption test, stability test, aging test, etc.).
Bluetooth PA Module MS88SFA COPYRIGHT STATEMENT This manual and all the contents contained in it are owned by Shenzhen Minew Technologies Co,. Ltd and are protected by Chinese laws and applicable international conventions related to copyright laws. The company has the right to change the content of this manual according to the technological development, and the revised version will not be notified otherwise.
Need help?
Do you have a question about the MS88SFA and is the answer not in the manual?
Questions and answers