Related Manuals for Kestrel 3500DT
Summary of Contents for Kestrel 3500DT
- Page 1 U S E R G U I D E 1 0 0 0 , 2 0 0 0 , 2 5 0 0 & 2 5 0 0 N V , 3 0 0 0 , 3 5 0 0 & 3 5 0 0 N V , 3 5 0 0 D T www.kestrelinstruments.com...
- Page 2 Before relying on Kestrel Weather & Environmental Meter readings, be sure to use care to either a) force air flow over the sensors by waving or slinging your meter through the air;...
-
Page 3: Table Of Contents
CONTENTS Features & Options ............4 This User Guide contains only the information you need to get started using your Kestrel meter. For FAQ’s, chat Getting to Know Your Kestrel ........5 and e-mail support, visit www.kestrelinstruments.com. Getting Started ............6 CONTACT US AT Setup + Options ............6... -
Page 4: Features & Options
The table below shows all Measurement screens available, listed with their corresponding screen icon and “Hint” abbreviation. Measurement Icon Hint Units of Measure 1000 2000 2500 3000 3500 3500DT • • • • • • Wind Speed ft/min km/h •... -
Page 5: Getting To Know Your Kestrel
US Patents SERIAL 5,783,753 www.nkhome.com 5,939,645 info@nkhome.com 610.447.1555 NUMBER HUMIDITY 3000 SENSOR NAVIGATION BUTTONS POWER/BACKLIGHT BATTERY DOOR: BUTTON CR2032 COIN CELL (Backlight N/A on K1000) *All Kestrel Meters with temperature measurement allow you to measure air, water and snow temperature. -
Page 6: Getting Started
The Kestrel Meter will automatically turn off if no buttons Adjust the Clock have been pressed for 45 minutes. *This applies to the 2500, 2500NV, 3500, 3500NV and 3500DT. • Adjust the clock. Simultaneously press Select Measurement Mode to access clock setting. While the time is •... -
Page 7: Barometric Pressure & Altitude Adjustment
ALTITUDE: KESTREL 2500 & KESTREL 3500 ONLY your Location • Use to highlight the “Altitude” The Kestrel Meter measures “station pressure,” which changes screen. in response to both changes in altitude and changes in atmosphere. Barometric pressure is a measurement of the air •... -
Page 8: Measurement Notes
• Use to view each Measurement screen in The Kestrel Meter may also be used to measure Hold Mode. the temperature of water and snow. Submerge the • To exit Hold Mode, hold down , then press thermistor portion (curly exposed wire in window again. -
Page 9: Maintenance & Service
MAINTENANCE & SERVICE ADDENDUM Replacing the Battery When your display becomes dim or disappears, you need to change the battery. Use a US nickel or similar coin to twist open the battery compartment. Replace battery with a new, clean CR2032 coin-cell battery, with positive side (+) facing up. -
Page 10: Sensor Calibration
Pressure Sensor (Kestrel 2500 & 3500) readings, we recommend you replace your impeller The Kestrel pressure sensor drift may be up to 1 at one-year intervals. Every replacement impel- mbar over 12 months. For high-precision applica-... -
Page 11: Warranty
WARRANTY CERTIFICATE Your Kestrel Weather/Environmental Meter is warrantied to be free of defects in materials and workmanship for a period of FIVE YEARS from the date of its first consumer purchase. NK will repair or replace any defective meter or part when notified within the warranty period, and will return the meter via domestic ground shipping or NK’s choice... - Page 12 Kestrel® Weather and Environmental Meters are designed and built in the USA NIELSEN-KELLERMAN 21 Creek Circle, Boothwyn, PA 19061 Phone: (610) 447-1555 Fax: (610) 447-1577 Web: Kestrelinstruments.com Email: info@NKhome.com Please register your Kestrel Meter at www.kestrelinstruments.com 319012_7_18.03.20...
Need help?
Do you have a question about the 3500DT and is the answer not in the manual?
Questions and answers