Page 2
Contents Introduction ..............................3 Modes ............................... 3 Access ................................ 3 Administration ............................4 Keypad Administration ..........................4 Examples ..............................5 Learn in a User Code ..........................5 Learn in a User ProxCard ........................5 Unlocking .............................. 5 Bypass the Active User Code or ProxCard .................... 5 FCC statement ............................
Page 3
Introduction This document details how to set up and use the MicroIQProx lock in local mode. These instructions are specific to locks in locker mode. Close proximity to the lock is required. Modes The MicroIQProx lock can operate in two modes: station mode or locker mode. It is easy to switch the mode of the lock if needed.
Page 4
Administration Keypad Administration Set up and administration of the MicroIQProx can also be performed directly with the keypad. If the lock was commissioned with the MicroTraq app, it will have to be decommissioned to use the keypad for programming. Programming Chart Page 4 of 6 11/4/2024...
Page 5
Turn the knob to the locked position. Unlocking With a ProxCard: Present the valid ProxCard to the lock. The MicroIQ icon should illuminate. If not, press the P to wake the lock and present the ProxCard card again. The green LED will illuminate and the knob can be turned to the unlocked position.
Page 6
With the master code: Press and hold the P on the lock keypad for 5 seconds. The green LED will illuminate. Enter 55 and then P on the lock keypad. The green and yellow LEDs will illuminate. Enter the master code and then P on the lock keypad. The green LED will flash three times.
Need help?
Do you have a question about the Prox CW and is the answer not in the manual?
Questions and answers