Advertisement
Quick Links
JetCam
Tips for use
Startup
Fill the system with water when idle.
Operation
Always use a roller guide or hose protection.
Increase pressure gradually up to a maximum of 160 bar. Do not execute
large, sudden pressure increases.
Handle the contacts in the nozzle (whisk) carefully.
Do not kink the first 5 m of the hose.
Use an impact guard with the camera head whenever possible.
Reduce the pressure when pulling the nozzle back to prevent damage.
Troubleshooting when removing the JetCam hose from the pipe:
- Rotate the hose and move it forward and back.
- Reduce or eliminate pressure.
- Do not pull the hose out using force or hydraulic pressure.
.
.
Find more information about the JetCam on our website at
www.enz.com
Find more information about the JetCam on our website at www.enz.com
Advertisement
Summary of Contents for enz JetCam
- Page 1 - Rotate the hose and move it forward and back. - Reduce or eliminate pressure. - Do not pull the hose out using force or hydraulic pressure. Find more information about the JetCam on our website at www.enz.com Find more information about the JetCam on our website at www.enz.com...
- Page 2 After use: - Check the nozzle, hose, steering piece, and camera head for wear. - Blow out the JetCam with compressed air via the ½” water connection. Allow it to dry. Remove visible soiling from the system. - Treat the nozzle with biodegradable preservative spray.
Need help?
Do you have a question about the JetCam and is the answer not in the manual?
Questions and answers