KwikGoal 6A401 Instructions

1. Unpack all parts and check for damage that may have occurred during shipping. If damage has occurred,
notify Kwik Goal immediately. Lay out all parts. Remove all cardboard and packaging immediately. Wet or
damp packaging may damage contents.
2. Read through entire instruction before beginning assembly and installation.
NOTE: Components may be packaged in one or more additional boxes.
3. Loosen the wing nut connecting the upper and lower
handles, and the two lower handle connection wings nuts,
one on each side of the unit. Lift up and unfold the handle
assembly from the body of the striper so that the handle is
fully extended.
5. Swivel the handle assembly backwards so that the slot at the bottom of the handle catches on the studs
exposed by the lower handle connection wing nuts loosened in step 3. Tighten the wing nuts until snug to
secure the handle in position.
Sports equipment not in use must be disassembled and stored in a safe, secure place.
equipment should not be left unattended.
modifications to this or any Kwik Goal product will void any and all warranties.
INSTRUCTIONS FOR 6A401 WET STRIPER
Wing Nut
Lower Handle
Connection Wing Nut
***CAUTION***
Sports equipment should be checked for safety on a regular basis. Any
140 Pacific Drive Quakertown, PA 18951
800-531-4252 Kwikgoal.com
©
4. Secure the upper and lower handles
together by tightening the wing nut
loosened in step 3 until the connection is
held firm.
2024 Kwik Goal Ltd.
Upper Handle
Lower Handle
Assembled sports
Wing Nut
NZ490 Rev. 05/06/24