V25 / V27 Chassis Down to 1 PRODUCT SAFETY NOTICE Many electrical and mechanical parts in television receivers have special safety related characteristics. These characteris- tics are often not evident from visual inspection nor can the protection afforded by them necessarily be obtained by using replacement components rated for higher voltage, wattage, etc.
V25 / V27 Chassis Down to 1 CABINET DISASSEMBLY (FRONT VIEW) Typical Procedure - Disassembly will vary by model. For exact procedures by model, refer to the Service Manual. Front Cabinet Disassembly 1. Remove the Speaker Grille by pulling forward. 2.
Page 6
V25 / V27 Chassis Down to 1 CABINET DISASSEMBLY (REAR VIEW) Typical Procedure - Disassembly will vary by model. For exact procedures by model, refer to the Service Manual. Rear Cabinet Disassembly 1. Remove the Back Board by removing screws (a), and screws (b). 2.
V25 / V27 Chassis Down to 1 CABINET SEPARATION PROCEDURE Typical Procedure - Disassembly will vary by model. For exact procedures by model, refer to the Service Manual. 65 & 73 Inch Models Cabinet Separation Procedure 1. Pull the Speaker Grill from the cabinet. 2.
V25 / V27 Chassis Down to 1 Troubleshooting Troubleshooting Steps: 1. If the Power LED is continuously flashing or if other TV controls seem locked, perform a System Reset by pressing the front panel button or by removing and re-applying AC power. 2.
Page 9
V25 / V27 Chassis Down to 1 V25 & V27 Symptom/Cause Information Symptom Other Possibilities Most Likely Video Problems, all Inputs & Menu bad. Audio OK PCB-SIGNAL PCB-CRTs, PCB-DM3 Video&Audio Problems. All signals bad. HV is OK PCB-SIGNAL PCB-DM3 Analog Tuning problems. External Inputs & Digital OK PCB-SIGNAL PCB-TERMINAL...
V25 / V27 Chassis Down to 1 TUNER PCB Locations & Functions SIGNAL HDMI TERMINAL MAIN PCB-DM3 PC B-Terminal PCB -Signal NetCommand PIP-P OP A/V Inputs Control uPC IEEE1394 Picture Format A/V Selection C ard Viewer 3:2 Pull D own 3D-Y/C Convergence OSD-Menus...
Need help?
Do you have a question about the WS-48515 and is the answer not in the manual?
Questions and answers