Advertisement
Quick Links
HC-XII.
BIBO Cleaning Cartridge
BIBO descaling
instructions
Contents
1.
HC-XII cleaning cartride
2.
Screw cap
3.
Cartridge stand
4.
Cartridge key
5.
Protective gloves
6.
Acid PH test strips
7.
Dissolvable tablets
a.
1 x sanitising tablet (cold tank)
b.
5 x descaling tablet (hot tank)
Safety tips & guidance
The BIBO descaling tablet contains citric acid – MSDS
available upon request. The BIBO sanitising tablet contains
sodium carbonate and sodium percarbonate – MSDS available
upon request. Wear the protective gloves provided whilst handling
dissolvable tablets.
WARNING – tablets can cause skin irritation and serious eye
irritation. Wash hands thoroughly after handling.
IF IN EYES: rinse cautiously with water for several minutes.
Remove contact lenses if possible.
IF ON SKIN: Wash hands with plenty of soap and water. If skin
irritation occurs, seek medical attention/advice. You must not
drink from your BIBO until the descaling and sanitising has been
completed and the filter has been replaced.
The entire descaling and sanitising process will take
approximately 1hr 15mins to complete.
You will need a 1L measuring jug suitable for dispensing
hot water into.
1.
Advertisement
Summary of Contents for Bibo HC-XII
- Page 1 IF ON SKIN: Wash hands with plenty of soap and water. If skin Contents irritation occurs, seek medical attention/advice. You must not drink from your BIBO until the descaling and sanitising has been HC-XII cleaning cartride completed and the filter has been replaced.
- Page 2 Turn the blue shut off valve at the back of your BIBO to the Wearing the gloves provided, dispense 250ml of hot water Lorem ipsum into a measuring jug. “off” position and dispense a small amount of cold water. Carefully drop the 5 x descaling tablets into your measuring Remove the lid on the top of your BBIO.
- Page 3 BIBO and discard. Remove the cleaning cartridge from your BIBO by turning it anti-clockwise. If you are sanitising your BIBO right away, please move onto the BIBO sanitising instructions. (pg. 5) If not, continue with the instructions below. Insert your filter cartridge into your BIBO by turning it Remove the screw from the top of the cleaning cartridge, empty clockwise into place.
- Page 4 Dispense a further 1L of water into your measuring jug and test the water using the acid PH test strips provided. If your test strip remains BLUE: Your BIBO is now safe to use. If your test strip turns RED: Keep dispensing water until all the residual cleaning solution has been flushed from the system.
- Page 5 IF ON SKIN: Wash hands with plenty of soap and water. If skin Contents irritation occurs, seek medical attention/advice. You must not drink from your BIBO until the descaling and sanitisation has been HC-XII cleaning cartride Screw cap completed and the filter has been replaced.
- Page 6 Turn the blue shut off valve at the back of your BIBO to the Wearing the gloves provided, dispense 250ml of hot water into a measuring jug. “off” position and dispense a small amount of cold water. . Carefully drop the 1 x sanitising tablet into your measuring Remove the lid on the top of your BIBO.
- Page 7 Place your measuring jug under the dispense nozzles of your BIBO. Dispense 1L of cold water and discard. Wait 30 minutes - DO NOT USE YOUR BIBO DURING THIS TIME! Once fully dry, refit cartridge stand onto your cleaning cartridge for storage and to protect the seal.
- Page 8 Dispense 3L of cold water into your measuring jug and discard. Replace the lid on the top of your BIBO. BIBO Ltd Unit 15, Your BIBO is now ready to use! Blenheim Sawmills Swan Lane, Combe, REMEMBER: Your cleaning cartridge is reusable, so store...
Need help?
Do you have a question about the HC-XII and is the answer not in the manual?
Questions and answers