ProLinx 46MRF Manual

Wireless RF Remote Control and Motion
Activated LED Light
MODEL NO.: 46MRF
Location of Controls
1. 6 Warm White (3000K) and 6 Cool White (8000K) LEDs & Radio Frequency Receiver
2. Diffused Lens
3. Motion Sensor
4. Light Sensor
5. Battery Compartment/Mounting Bracket*
Remote Control Buttons
6. Power on/power off
7. Adjust color of light (+ / -)
8. White/Warm White Button
9. Motion ON (M/ON)/Motion OFF (M/OFF)
10. Auto-off timer for 15, 30, 60 or 120 minutes
11. Battery Compartment*
*On back of unit/remote
Screw Installation Instructions
NOTE: Prepare 3 x 1.5V D Battery (not included).
1. Remove the Mounting Bracket by pushing to the direction with OPEN arrow.
2. Drill two pilot holes in the location where you want to mount the light. Use the detachable mounting
bracket as a guide for the pilot holes.
3. Place screws (included) in pre-drilled holes. Tighten screws until mounting bracket is secure to
surface. Do not over tighten.
4. Fasten the light to the mounting bracket by aligning tabs and turning light clockwise.
Operating Directions
Motion Sensor
The red indicator light will FLASH when motion sensor feature is ON
The LED Night Light is designed with automatic light sensor which allows Motion Sensor only
operates at night or in dark conditions. Press the "M/ON" button to turn ON motion sensor feature.
- The light will turn ON automatically when motion is detected.
- The light will also shut OFF automatically after 20 seconds when no motion is detected.
- It detects motion within 18 feet (5.5 meters) of the motion sensor.
Remote Operation Using the Wireless RF Remote Control
Press the top left button to turn all white and warm white LEDs ON. Press the top right button to turn
all LEDs OFF.
Adjust color of light from warm white to white with the "+" button or from white to warm white with
the "-" button when light is ON.
Turn the white light ON directly by pressing "White" button or turn the warm white light ON by
pressing "Yellow" button when light is ON.
Turn ON motion sensor feature by pressing "M/ON" button or turn OFF motion sensor feature by
pressing "M/OFF" button. Light will flash once to confirm signal received. Remote control features
are still working.
The auto-off timer feature will be set by pressing the corresponding 15, 30, 60 or 120 button on
the remote control. For best performance, point remote to the light within 80 feet (24 meters). Light
will flash once to confirm signal received.
130*190MM