Advertisement
Advertisement
Table of Contents
Summary of Contents for AccessPRO PROKEYPADS V2
- Page 1 User Manual PROKEYPADSV2...
-
Page 2: Specifications
Specifications Operating Voltage: 12 VDC Operating Current: 60 mA (idle), 95 mA (operation) Operating Temperature: -4 to 158°F (-20 to 70°C) Number of Users: - Output 1: 1000 (codes and/or cards) and 50 dummy codes - Output 2: 100 (codes and/or cards) and 10 dummy codes Proximity Reader: Standard 125KHz proximity reader Visitor Codes: 50 visitor codes... -
Page 3: Turning On The Equipment
Turning on the equipment When turning on the equipment, it will emit a constant beep for 1 minute. It is possible to stop the alarm by pressing: 1 2 # Entering programming mode • To enter programming mode, press 0 0 0 0 * *... - Page 4 Entering programming mode in case of forgetting the master code • Disconnect the equipment for one minute. • Turn the equipment back on. • Press the request for exit button (connected between EG IN - GND). • Press the code 2828 ** •...
-
Page 5: Factory Reset
Factory reset • Enter programming mode. • Press 9999 # • The equipment will start flashing the amber LED. • When finished, the equipment will emit a few beeps and the amber LED will remain steady. • Press ** to exit programming. - Page 6 Master code change • Enter programming mode. • Press 01. • Enter the new master code of 4 to 8 digits. • Confirm by pressing #. • Press ** to exit programming. Example: Programming master code 2233 0000 + ** + 01 + 2233 + #...
-
Page 7: Superuser Code
Superuser code The superuser has two main functions, being able to activate either of the two outputs. Programming a superuser code • Enter the programming menu • Press 02 • Enter the 4 to 8 digit password • Validate with # Example: Programming a superuser code 2580. -
Page 8: User Registration
User registration User registration is based on the output they will activate, output 1 or output 2, and the verification method to be used, card, password, or card+password. Programming a user • Enter programming mode. • Enter the output to program (10 for output 1, 20 for output 2). -
Page 9: Deleting A User
Deleting a user • Delete a password – Enter programming mode. – Press the code for the output where the password will be deleted (10 for output 1, 20 for output 2) – Press 5. – Enter the user ID (xxx). –... - Page 10 Visitor registration Visitors can only activate output 1. • Program a visitor code. – Enter programming mode. – Type 40. – Enter the visitor ID (01 – 50). – Validity period (00 or 01 - 99). – Enter the 4 to 8 digit password. –...
- Page 11 Relay activation time • Enter programming mode • Press which of the two outputs will be modified (51 for output 1 and 52 for output 2). • Select how much time will be configured (0: ON/OFF, 1-99999 seconds) • Press # to accept the changes. Example: Configure the activation time of relay for output 1 to 5 seconds.
- Page 12 Connection • The equipment has an energized relay output, it is a 12VDC output.
- Page 13 Changing the state of relay output 1 • This change is made using Jumper J1 on the keyboard board.
Need help?
Do you have a question about the PROKEYPADS V2 and is the answer not in the manual?
Questions and answers