Advertisement
Quick Links
Advertisement
Summary of Contents for PLC EDS
- Page 1 SENSORS INSTALLATION AND MAINTENANCE MANUAL (IMM) 205 EDS Rev3 A Division of PLCMultipoint...
- Page 2 INTRODUCTION The EDS sensor is designed to work directly with electronic dimming ballast’s Class 2 Low Voltage Power Supply, such as the Advance ™ Mark VII and others using a 0-10v dimming control signal. It is ideal for daylight control or task tuning and to compensate for lumen depreciation.
- Page 3 The EDS sensor comes equipped with a built in amplifi er and a 20 turn potentiometer to adjust the limits of the sensor. Insert the supplied calibration tool through the port in the sensor to engage the potentiometer screw head.
- Page 4 EDS SENSORS INSTALLATION AND MAINTENANCE MANUAL (IMM) MAINTENANCE Every 2 months wipe the lens clean with a non-scratching clean cloth and ensure that no foreign debris remains. Check the housing for damage such as cracks, burns or other deformations. Check that no moisture has penetrated the sensor, as this will likely render it inoperable.
Need help?
Do you have a question about the EDS and is the answer not in the manual?
Questions and answers