Black & Decker K2 QDC100 Series Installation Instructions Manual

ENGLISH
INSTALLATION INSTRUCTIONS
TM
DOOR HANDING
INSIDE
LEFT HAND
OUTSIDE
INSIDE
LEFT HAND
REVERSE BEVEL
OUTSIDE
DOOR HANDS DETERMINED FROM OUTSIDE
SPRING POWER / SIZING
MAXIMUM
DOOR
DOOR WIDTH
CLOSER
SIZE
EXTERIOR
INTERIOR
(SWING OUT)
BF
5 lb-f
1 28" (0.71m) 32" (0.81m)
2 32" (0.81m)
36" (0.91m)
3 36" (0.91m) 42" (1.07m)
4 42" (1.07m) 48" (1.22m)
5 54" (1.37m)
48" (1.22m)
6
54" (1.37m) 58" (1.47m)
TURNS REQUIRED ARE APPROXIMATE DUE TO VARIOUS DOOR CONDITIONS AND
LOCATIONS. FURTHER ADJUSTMENTS FOR SPRING POWER MIGHT BE NECESSARY
TO SUIT YOUR REQUIREMENTS.
THREE INSTALLATION OPTIONS: A, B, AND C.
OPTION A: REGULAR ARM MOUNT
(PULL SIDE)
RIGHT HAND DOOR = RH
LEFT HAND REVERSE = LHR
The closing force for series QDC111BF door closers is an adjustable form of a size 1 to a size 6, as
outllined in ANSI Standard A156.4. When these series of door closers are installed and adjusted to
conform to ADA reduced opening force requirements (5 lbs max) for interiror doors, they may not have
adequate closing force to reliably close and latch door. Power adjustments charted on this page are
recommended where possible to ensure proper door control.
QDC100 SERIES
DOOR CLOSER
RIGHT HAND
RIGHT HAND
REVERSE BEVEL
FULL TURNS OF POWER
ADJUSTING SCREW
CW = clockwise CCW = counterclockwise
QDC111 QDC111BF
14 CCW
12 CCW
6 CCW
8 CCW
3 CCW
0 (PRESET) 0 (PRESET)
3 CW
7 CW
12 CW
*
NOTICE
OPTION B: TOP JAMB MOUNT
CONTROL RANGE
BACK CHECK
*
LATCH SPEED
4 CW
CONTROL SCREW
SWEEP SPEED
CONTROL SCREW
DELAYED ACTION
CONTROL SCREW
(PUSH SIDE)
RIGHT HAND DOOR = RH
LEFT HAND REVERSE = LHR
NOTICE
IT IS IMPORTANT TO CAREFULLY
FOLLOW ALL INSTALLATION AND
MOUNTING INSTRUCTIONS WHEN
INSTALLING ANY DOOR CLOSER.
DELAYED ACTION
Increase
Increase
Decrease
Decrease
SWEEP
1
4
2
3
BACK CHECK
SCREW
SPRING POWER
ADJUSTING SCREW
OPTION C: PARALLEL MOUNT
(PUSH SIDE)
LEFT HAND DOOR = LH
LEFT HAND REVERSE = LHR
By law, the Americans with Disabilities Act (ADA)
may require that door closer installation comply
with accessibility guidelines.
Slow
Fast
LATCH
Slow
Fast
COVER
SCREW
HOLES
HEX
WRENCH
CCW
+
CW
43520-01