Page 4
Remove the fixed shaft,Using the front axle.
Page 5
Place the front fender under the fork. Align the headlight wires and plug them in. Install the fender on the bracket and tighten the bolts.
Page 6
Adjust to the desired height and close the quick release clamp lever.
Page 8
Adjust the seat to yourdesired height and closethe lever of the seatpost clamp.
Page 9
After turning off the power to the e-bike, insert the power key into the battery key socket. Fully insert the battery key into the keyhole. Push the key and turn it counterclockwise to the end to unlock the battery. Then pull out the battery and slowly remove it.
Page 10
Locate the charging cover. Open the charging cover. Place in a safe location for charging, red means charging in progress, green means the battery is full.
Page 12
1. Function overview and Functional areas Functional overview The YL81F display offers a variety of features to suit your riding needs, including: • Battery level indicator • Pedal assist(PAS)level indicator • Speed (current speed, maximum speed, average speed) • Mileage display(single and total mileage) •...
Page 13
Button definitions The YL81F display is equipped with five buttons on the corresponding ,plus , minus operating unit: poweron/off button and toggle Error code display If there is a fault occurs in the electronic system of the electric bicycle, the display will automatically show an error code, see Schedule 1 for a detailed definition of the error code.
Page 14
* It is not recommended to plug or unplug the Micro connector while the power is on, as it can cause irreversible damage to the electrical components.*...
Page 15
Do not store or charge the battery in high temperature ranges.
Need help?
Do you have a question about the HYPER V2 and is the answer not in the manual?
Questions and answers