Download Print this page

Stella ZG-027-GRYWSH-GG Assembly Instructions Manual

Bookcase

Advertisement

Quick Links

ASSEMBLY INSTRUCTIONS
Before You Begin: A Phillips screwdriver is required for assembly (Not Included).
Please identify all component parts and hardware pieces required before you begin. Carefully remove all of the
components from the packaging and set aside for assembly. Assemble on a soft surface to prevent scratching
during assembly.
Caution:
Tighten all components securely before use. Failure to do so may result in personal injury.
DO NOT use any sharp objects to open plastic wrapped components as damage to product or components may
result.
Warning:
CHOKING HAZARD - Small Parts. Adult Assembly Required.
DO NOT ALLOW CHILDREN TO CLIMB ON FURNITURE
Serious or fatal injuries can occur from furniture tipping over. You must install Tipping Restraint Hardware (where
included) to help prevent the unit from tipping and causing accidental injury, instability, death or damage. The
tipping restraint is intended only as a safety measure, it is not a substitute for proper adult supervision.
To help prevent furniture from tipping over it must be permanently attached to the wall. Anti-Tip Safety Wall
Straps suitable for the unit weight and wall materials (if not included) should be purchased and installed.
Thank you for your purchase!
Bookcase

Advertisement

loading
Need help?

Need help?

Do you have a question about the ZG-027-GRYWSH-GG and is the answer not in the manual?

Questions and answers

Summary of Contents for Stella ZG-027-GRYWSH-GG

  • Page 1 Thank you for your purchase! Bookcase ASSEMBLY INSTRUCTIONS Before You Begin: A Phillips screwdriver is required for assembly (Not Included). Please identify all component parts and hardware pieces required before you begin. Carefully remove all of the components from the packaging and set aside for assembly. Assemble on a soft surface to prevent scratching during assembly.
  • Page 2 Safety and Care Advice Important – Please read these instructions fully before starting assembly • Check you have all the • During assembly do not stand • To reduce components and tools listed on or put weight on the product, the likelihood of the following pages.
  • Page 3 Hardware Please check you have all the panels listed below Note: The quantitie below are the correcet amount to complete the assembly. In some cases more fittings may be supplied than are required. Male Camlock x 6 Female Camlock x 6 Dowel x 6 6*20mm Screw x 12 Hex Key M4 x 1...
  • Page 4 Using Camlocks Step 1 Step 2 DO NOT OVER TIGHTEN. Connect the male Push the male camlock NE PAS SERRER EXCESSIVEMENT. camlock as diected in into the entry hole. the assembly instructions using a scewdriver . Step 4 Step 3 Insert the female Turn the female camlock camlock as shown in the...
  • Page 5 Parts...
  • Page 6 Assembly Instructions Step 1 Step 2...
  • Page 7 Assembly Instructions Step 3 Step 4...
  • Page 8 Assembly Instructions Step 5 Step 6...
  • Page 9 Assembly Instructions Step 7 Step 8...
  • Page 10 Assembly Instructions Step 9 Step 10...
  • Page 11 Assembly Instructions Step 11 No.3 panel move a little bit to the bottom Step 12...
  • Page 12 Assembly Instructions Step 13 Step 14...
  • Page 13 Assembly Instructions Step 15 Step 16...
  • Page 14 Assembly Instructions Step 17 Step 18...
  • Page 15 Assembly Instructions Step 19 The unit is floor standing, but it is recommended that the unit is secured to the wall. 1. Move the unit into desired position. 2. Mark the wall with a suitable scribe the position of the fixing holes.